Front wheel well plastic question?

[NYC-SE]

Took a look at my fender liners today. Sure enough the plastic had popped out and was hanging slightly below the fender. Just popped it back in above the fender lip and all is now OK. It doesn't seem as if there is anything holding the liner in that position. There are clips at the back of the liner, behind the wheel where it is attached to the body, but there is nothing to hold the liner in position at the top. I guess the natural springiness of the plastic is supposed to keep it snapped in there. No match for the pothole strewn roads around here, but it is simple enough to pop it back into place.

[Pinchlite]

Originally Posted by NYC-SE

Took a look at my fender liners today. Sure enough the plastic had popped out and was hanging slightly below the fender. Just popped it back in above the fender lip and all is now OK. It doesn't seem as if there is anything holding the liner in that position. There are clips at the back of the liner, behind the wheel where it is attached to the body, but there is nothing to hold the liner in position at the top. I guess the natural springiness of the plastic is supposed to keep it snapped in there. No match for the pothole strewn roads around here, but it is simple enough to pop it back into place.

From looking more closely my yaris is desighned to have the plastic outside fender lip.so if you look at the wheel well you see the black plastic.Crap design to be honest as it looks like shit.

Canadian models are different then other countries and perhaps even differs from state to state within the US?

I ordered a bunch of new wheel well clips aswell btw.Not sure what to do as I tried to put inside fender well but it all buckles and causes the tire to hit when turning sharp.Total garbage to be quite honest but you get what you pay for.