Sushi the Yaris

[hotracer_05]

Originally Posted by m.flores.0928

Good to know, I wasn't sure how the badge was held on.

What about that long trim piece under it? How is that removed?


Sent from my iPhone using Tapatalk

its held on by 2 (maybe 3 or 4) nuts from the back. you'll have to remove the plastic trim piece on the back door to get to them. the front emblem doesn't have any tape, it just clips in

[m.flores.0928]

Originally Posted by hotracer_05

its held on by 2 nuts from the back. you'll have to remove the plastic trim piece on the back door to get to them. the front emblem doesn't have any tape, it just clips in

Awesome, thanks! Did you rattle can it? What paint would you use?

Also, do you know anything about spray-tinted tail lights? I've been looking for that too.


Sent from my iPhone using Tapatalk

[hotracer_05]

Originally Posted by m.flores.0928

Awesome, thanks! Did you rattle can it? What paint would you use?

Also, do you know anything about spray-tinted tail lights? I've been looking for that too.


Sent from my iPhone using Tapatalk

I used a self etching primer that bonds to plastic, it will say it on the can. I have some spray on tint, but to be honest Ive never had a finished product Ive liked lol. BUT i think that has to do more with my ability to paint/prep

The air vent are two pieces that clip together, that then clip to that gray trim piece. you use a flat head screw driver to pry the tabs up