Chasing a Vibration - Toyota Yaris Forums

CharlieBravo · 12-23-2019, 06:54 PM

UPDATE:

Everything put back together. Fluid re-added to transmission. I'm guessing its about 0.1qt less than whatever it had at the start. Little bit spilled out before I could put the pan in place when I pulled the axle out. Little bit leaked out as I was pouring it back into the transmission. There's probably a little bit still in the pan, funnel, and tubing.

Took it for a test drive. Nothing fell apart...yet. And the noise/vibration seems to be gone! The only thing I know for sure is that the passenger bearing was failing. Making a grinding noise when free spinning the wheel and noticed grease coming out of the bearing when I pulled it out of the hub.

I guess mission accomplished for now.....

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mystery(misery?) vibration, I am determined to find a solution.	seatech30	DIY / Maintenance / Service	4	06-16-2019 07:48 PM
Excessive vibration over 60mph. Suspension related?	Aclosefriend	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	17	03-29-2016 07:06 PM
Vibration on idle & rough start	Murtaza_murti	DIY / Maintenance / Service	25	08-15-2015 01:58 PM
Yaris vibration abnormality	talhahs	DIY / Maintenance / Service	13	04-13-2013 11:07 PM
Pulsating Vibration	dbudworth	General Yaris / Vitz Discussion	5	03-28-2011 05:06 PM

12-23-2019, 06:54 PM	#6
CharlieBravo Drives: 2007 Yaris HB Join Date: Dec 2011 Location: Florida Posts: 39	UPDATE: Everything put back together. Fluid re-added to transmission. I'm guessing its about 0.1qt less than whatever it had at the start. Little bit spilled out before I could put the pan in place when I pulled the axle out. Little bit leaked out as I was pouring it back into the transmission. There's probably a little bit still in the pan, funnel, and tubing. Took it for a test drive. Nothing fell apart...yet. And the noise/vibration seems to be gone! The only thing I know for sure is that the passenger bearing was failing. Making a grinding noise when free spinning the wheel and noticed grease coming out of the bearing when I pulled it out of the hub. I guess mission accomplished for now.....