 |
 |
|
|
04-21-2022, 11:47 PM
|
#3 |
|
Gen 3 > Gen 2
Drives: NCP131, F-150 Join Date: Jul 2019
Location: Red Deer, AB
Posts: 509
|
I have an aluminum one on my car that I got from Aliexpress, it cost under 30 bucks and is actually good quality. Just be careful when working around it if the engine is hot as the aluminum holds a lot of heat(way more than the plastic one) and will burn your arm, I know from experience.
__________________
2014 NCP131 5 Speed 2007 F150 4.2L 5 Speed 2013 Rav4 LE AWD Autotragic - Wife's 
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| T Montague's 2zr swap - '08 m/t sedan some extra info | tmontague | Performance Modifications | 285 | 04-20-2021 12:56 PM |
| What is a (or the) coorect coolant & amount for a Yaris? | RMcG | DIY / Maintenance / Service | 0 | 06-19-2019 06:36 PM |
| Removal of petrol filler neck and wheel arch welding | SilverChariot | DIY / Maintenance / Service | 1 | 06-18-2017 08:44 AM |
| Coolant Level in filler neck? | CB900F2 | DIY / Maintenance / Service | 26 | 05-18-2014 06:09 AM |
| toyota yaris sedan, missing flap just inside fuel filler neck | 41magmag41 | General Yaris / Vitz Discussion | 3 | 10-17-2010 05:43 PM |
Threaded Mode