![]() |
|
|
|
#2 |
![]() ![]() ![]() ![]() ![]() Drives: 2007 5dr canadian import Join Date: Dec 2016
Location: pacific north WET
Posts: 1,025
|
well youve got a few options
the arm rests on a shaft, then below that is a pin and push rod(these often click on many makes n models) then at the end of the pushrod it goes into the power booster and thru the firewall..again a good click point..youve also got the brake switch itself..which if loose or going bad will click or squeek if its inside the car stick your head under the dash and wiggle it around and finding it isnt hard |
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Brake Failure only when pressing the pedal gently | paraklas | General Yaris / Vitz Discussion | 1 | 01-17-2021 12:26 PM |
| Soggy Brake Pedal | 06YarisRS | DIY / Maintenance / Service | 3 | 07-14-2020 12:56 PM |
| Hiss or pfft when pressing brake pedal | kwk442 | DIY / Maintenance / Service | 3 | 06-03-2017 07:10 AM |
| red hot brake shoes | tommo | DIY / Maintenance / Service | 1 | 08-31-2011 08:34 PM |
| Brake pedal vibrates-not rotor problem | rradhay | DIY / Maintenance / Service | 9 | 11-12-2010 10:10 AM |