Scangauge finaly available

[echo_hrs]

Originally Posted by birdy

how hard was the install? for a person with auto knowledge? I have installed turbo kits flawlessly so I know my way around cars. is it like plug and play or is there any wire cutting and splicing..

It plugs into the OBDII diagnostic connector under the dash...This powers it, so no additional wires needed....

Cheers

[pennystocks]

Yea, easy install, i just took the panels by the radio off and ran the wire to infront of the gauge cluster.

[birdy]

sweet thats good to hear

[eight_heads]

i'm wondering how much the driver compartment door will be too, i'd like to mount my tach in it and i plan on also buying a scangauge2...

[TRD_Yaris]

Awesome! Thanks for the Write-up on the Scangauge unit!!! I'm gonnna have to get me one of those. Does the MPG seem correct after a few tanks of gas?? do you end up filling up with the same amount as it states you use?


THANKS AGAIN!!

[ECHOKnight2000]

Originally Posted by TRD_Yaris

Awesome! Thanks for the Write-up on the Scangauge unit!!! I'm gonnna have to get me one of those. Does the MPG seem correct after a few tanks of gas?? do you end up filling up with the same amount as it states you use?


THANKS AGAIN!!

I have a scanguage II and its amazing! I asked about the mpg in another thread and I believe its fairly correct...there's instructions in the booklet on how to set up the device for mpg...you have to put in your engine size, size of tank and go to the fill-up section and push done everytime you fill up. It tells you miles you driven, average mph, max rpm just driven and so on.