 |
 |
|
|
|
|
09-12-2011, 07:35 PM
|
#1 |
 Drives: Yaris 2003 Join Date: Apr 2010
Location: York
Posts: 7
|
Handbrake Loose
Hi,
Could any of you tell me how easy is it to adjust the handbrake on 2003 Yaris. When I first pull up the handbrake it doesn’t hold the car sufficiently and if on a slight incline it begins to roll. I have to then pull the handbrake up to it’s highest possible point to have any effect. Is it possible to tighten the handbrake. Thanks for any advice Roth 
Last edited by Roth5150; 09-12-2011 at 07:42 PM. Reason: Didn't say what Year of car |
|
|
|
09-12-2011, 10:03 PM
|
#2 |
 Drives: red bare bone yaris hb 3dr Join Date: May 2009
Location: columbus
Posts: 1,022
|
There's the bolt under the handbrake lever, you should see it connect to a steel wire ... If I'm not mistaken, u should tighten it clockwise ... And test it afterwards ..
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unknown plug under handbrake | o.molina1 | DIY / Maintenance / Service | 1 | 01-29-2011 02:35 PM |
| how to break loose pulley bolt | yaris9876 | DIY / Maintenance / Service | 10 | 05-16-2010 02:55 PM |
| Had my brakes done....now handbrake is harder to pull. | captainm27 | General Yaris / Vitz Discussion | 7 | 05-10-2010 08:00 PM |
| Loose shifter knob | dvspindler | Cosmetic Modifications (Exterior/Interior) | 7 | 08-06-2009 05:07 PM |
| Auto trans : Drive to Park + Handbrake : was not in park... | Maxh91 | General Yaris / Vitz Discussion | 7 | 06-11-2009 07:37 PM |
Hybrid Mode
