RHD Vitz RS cluster - Page 2 - Toyota Yaris Forums

Kioshi · 10-13-2009, 03:51 PM

I wanted to say if it was similar to ECU or that actually..but thanks for clarifying CTScott. And very much appreciated for the link. I will look on that for the 08 ECU after cluster tests....

I dont mind spending another $100 on making this cluster work.

I know Toyota wont install an 08 ECU on an 07...so best possible place to get this done?

I just checked that link out Scott, no ECU on there in the list for the Yaris...I'll check ebay mostly as i dont think i have time to go to junkyards and look for one...

Gideon · 10-13-2009, 04:06 PM

Yeah Kioshi there are tons of ECUs on eBay for about $150.

Although I found this one interesting:

CTScott · 10-13-2009, 04:31 PM

Quote:

Originally Posted by Gideon

Yeah Kioshi there are tons of ECUs on eBay for about $150.

Although I found this one interesting:

That's for a 1st gen Vitz.

Gideon · 10-13-2009, 05:00 PM

Damn, I thought it looked different than our ECU too. Boo.

CTScott · 10-13-2009, 04:25 PM

Quote:

Originally Posted by Kioshi

I wanted to say if it was similar to ECU or that actually..but thanks for clarifying CTScott. And very much appreciated for the link. I will look on that for the 08 ECU after cluster tests....

I dont mind spending another $100 on making this cluster work.

I know Toyota wont install an 08 ECU on an 07...so best possible place to get this done?

I just checked that link out Scott, no ECU on there in the list for the Yaris...I'll check ebay mostly as i dont think i have time to go to junkyards and look for one...

Best place is right in your driveway. 4 screws and 2 connectors and your done.

Kioshi · 10-13-2009, 04:10 PM

^^^^Wow.....

Lots of 2007 ECUs on there..I'll keep looking for an 08 manual tranny LB ecu..

If you guys happen to find them before me, post the link on here kindly

Kioshi · 10-13-2009, 07:32 PM

I did search for a DIY on swapping ECUs...and found this thread - http://www.yarisworld.com/forums/sho...light=ecu+swap

Mike aka mikenacarato says all 09' are equipped w/ ABS, have to find out if all 08's were ABS as well.....

CTScott - this is the location of the ECU i have to swap for an 08 one right?

Sedan and hatchback share the same ECU? or should i get a hatchback one specifically?
Do i have to remove the whole dash, looks to be that way to get to the 4 screws....

mr9865 · 10-13-2009, 07:33 PM

not all 08s had abs

CTScott · 10-13-2009, 08:50 PM

That's the main body ECU (which handles things like door locks on a so equipped car). The ECM is the silver box under the hood against the firewall on the left side (with the two big black connectors).

Sir A.Y. Atoyot · 10-14-2009, 09:07 PM

Quote:

Originally Posted by CTScott

That's the main body ECU (which handles things like door locks on a so equipped car). The ECM is the silver box under the hood against the firewall on the left side (with the two big black connectors).

Left side? I thought that the reference for the left and right sides of the car were the driver's left and right hands when seated behind the wheel. For example, on North American cars, the steering wheel is on the left side. The ECU is on the right side. Or am I wrong?

Kioshi · 10-14-2009, 12:37 AM

So I would need to be looking for Engine ECM/ECU, correct?

Are there reports of anyone having done this in the past, compatible....? CTScott, you have an Garm's ECU..is it identical to the 09's?
Going to small junkyard next week..

CTScott · 10-14-2009, 10:25 AM

Quote:

Originally Posted by Kioshi

So I would need to be looking for Engine ECM/ECU, correct?

Are there reports of anyone having done this in the past, compatible....? CTScott, you have an Garm's ECU..is it identical to the 09's?
Going to small junkyard next week..

Correct on what you are looking for.

The 06-09 ECMs all look identical, but there are different part numbers on them depending on the features of the car they are used on.

Kioshi · 10-14-2009, 12:22 PM

Now from what you've told me, the main features the Engine ECM needs to hold is: Manual tranny, liftback, and ABS?

Would a sedan ECU make a difference, or does it have to be liftback? Lots of sedan ECUs on ebay......

CTScott · 10-14-2009, 12:42 PM

Quote:

Originally Posted by Kioshi

Now from what you've told me, the main features the Engine ECM needs to hold is: Manual tranny, liftback, and ABS?

Would a sedan ECU make a difference, or does it have to be liftback? Lots of sedan ECUs on ebay......

Actually, if Gideon's car is non-ABS and the speedo worked, then you want a non-ABS one. If you put an ABS one in your car, it still may not work, since you don't have the Brake Actuator to send the speed info to the cluster.

I believe that a sedan ECM would be fine in a LB.

Kioshi · 10-14-2009, 01:00 PM

CTScott, Gideon confirmed to me that his car had ABS in it. Installing an ABS enabled ECM would enable to send speed info through brake actuator then for me? Or would i need to hunt down a brake actuator as well?

Ok, I'll dig up on sedan ECMs as well now...

CTScott · 10-14-2009, 01:19 PM

Quote:

Originally Posted by Kioshi

CTScott, Gideon confirmed to me that his car had ABS in it. Installing an ABS enabled ECM would enable to send speed info through brake actuator then for me? Or would i need to hunt down a brake actuator as well?

Ok, I'll dig up on sedan ECMs as well now...

You don't have ABS, so you don't have the brake actuator.

I really think that before you spend money on an ECM, that you should test it on an 08 with no ABS.

Kioshi · 10-14-2009, 08:15 PM

I'll go ahead and do that. But chances of finding someone with an 08 without ABS is slim to none, at least for me in California.. :(

I called my Toyota dealership today and they said they cannot install ABS on my car. Supposedly it comes from the factory installed... So I'm shit out of luck if ABS is required CTScott....

Update 3: SO i had a passenger sitting in my car and the airbag light indicator near the right side vent DOES turn on, but seatbelt indicator does NOT...thats fine for me...no more beep noise~

Do you know of anyone around you w/ an 08 non-ABS yaris lb CTScott? I could ship it out to you, me paying the expenses both ways...

CTScott · 10-14-2009, 08:27 PM

Quote:

Originally Posted by Kioshi

I'll go ahead and do that. But chances of finding someone with an 08 without ABS is slim to none, at least for me in California.. :(

I called my Toyota dealership today and they said they cannot install ABS on my car. Supposedly it comes from the factory installed... So I'm shit out of luck if ABS is required CTScott....

Update 3: SO i had a passenger sitting in my car and the airbag light indicator near the right side vent DOES turn on, but seatbelt indicator does NOT...thats fine for me...no more beep noise~

Do you know of anyone around you w/ an 08 non-ABS yaris lb CTScott? I could ship it out to you, me paying the expenses both ways...

Actually, Crashy is an 08 non-ABS LB.

10-13-2009, 03:51 PM	#1
Kioshi Heart Up! Vitz Drives: トヨタ Vitz Join Date: Jun 2007 Location: Fremont, CA Posts: 2,582	I wanted to say if it was similar to ECU or that actually..but thanks for clarifying CTScott. And very much appreciated for the link. I will look on that for the 08 ECU after cluster tests.... I dont mind spending another $100 on making this cluster work. I know Toyota wont install an 08 ECU on an 07...so best possible place to get this done? I just checked that link out Scott, no ECU on there in the list for the Yaris...I'll check ebay mostly as i dont think i have time to go to junkyards and look for one... Last edited by Kioshi; 10-13-2009 at 04:02 PM.

10-13-2009, 07:32 PM	#7
Kioshi Heart Up! Vitz Drives: トヨタ Vitz Join Date: Jun 2007 Location: Fremont, CA Posts: 2,582	I did search for a DIY on swapping ECUs...and found this thread - http://www.yarisworld.com/forums/sho...light=ecu+swap Mike aka mikenacarato says all 09' are equipped w/ ABS, have to find out if all 08's were ABS as well..... CTScott - this is the location of the ECU i have to swap for an 08 one right? Sedan and hatchback share the same ECU? or should i get a hatchback one specifically? Do i have to remove the whole dash, looks to be that way to get to the 4 screws.... Last edited by Kioshi; 10-13-2009 at 07:46 PM.

10-13-2009, 07:33 PM	#8
mr9865 $10.25/hr frying chicken View User's Garage Drives: 2012 Yaris L Join Date: Mar 2009 Location: Green Bay WI Posts: 262	not all 08s had abs __________________

10-14-2009, 12:37 AM	#11
Kioshi Heart Up! Vitz Drives: トヨタ Vitz Join Date: Jun 2007 Location: Fremont, CA Posts: 2,582	So I would need to be looking for Engine ECM/ECU, correct? Are there reports of anyone having done this in the past, compatible....? CTScott, you have an Garm's ECU..is it identical to the 09's? Going to small junkyard next week.. Last edited by Kioshi; 10-14-2009 at 03:34 AM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
My JDM Yaris..(Vitz Rs Wannabe) ^^	davinelika	Photo-Video-Media Gallery	20	10-05-2010 09:08 AM
OZ CLUSTER	Lewis	DIY / Maintenance / Service	226	11-15-2009 09:19 AM
FS: Gauge Cluster from '09 LB- $150	MGargano	Items for Sale by private party	14	10-05-2009 01:59 PM
A German Yaris/Vitz/Echo ;)	we-to-11	Photo-Video-Media Gallery	5	06-27-2007 09:26 PM
JDM Vitz Parts!!	MC-BPT	Sponsors Classifieds Area	20	06-20-2007 03:44 PM

10-13-2009, 04:06 PM	#2
Gideon ★weeaboo★ View User's Garage Drives: 2008 Bayou LB Join Date: Oct 2008 Location: Sunnyvale, CA Posts: 661	Yeah Kioshi there are tons of ECUs on eBay for about $150. Although I found this one interesting:

10-13-2009, 05:00 PM	#4
Gideon ★weeaboo★ View User's Garage Drives: 2008 Bayou LB Join Date: Oct 2008 Location: Sunnyvale, CA Posts: 661	Damn, I thought it looked different than our ECU too. Boo.

10-13-2009, 04:10 PM	#6
Kioshi Heart Up! Vitz Drives: トヨタ Vitz Join Date: Jun 2007 Location: Fremont, CA Posts: 2,582	^^^^Wow..... Lots of 2007 ECUs on there..I'll keep looking for an 08 manual tranny LB ecu.. If you guys happen to find them before me, post the link on here kindly

10-13-2009, 08:50 PM	#9
CTScott ULTIMATE View User's Garage Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008 Location: USA, CT Posts: 13,460	That's the main body ECU (which handles things like door locks on a so equipped car). The ECM is the silver box under the hood against the firewall on the left side (with the two big black connectors).

10-14-2009, 12:22 PM	#13
Kioshi Heart Up! Vitz Drives: トヨタ Vitz Join Date: Jun 2007 Location: Fremont, CA Posts: 2,582	Now from what you've told me, the main features the Engine ECM needs to hold is: Manual tranny, liftback, and ABS? Would a sedan ECU make a difference, or does it have to be liftback? Lots of sedan ECUs on ebay......

10-14-2009, 01:00 PM	#15
Kioshi Heart Up! Vitz Drives: トヨタ Vitz Join Date: Jun 2007 Location: Fremont, CA Posts: 2,582	CTScott, Gideon confirmed to me that his car had ABS in it. Installing an ABS enabled ECM would enable to send speed info through brake actuator then for me? Or would i need to hunt down a brake actuator as well? Ok, I'll dig up on sedan ECMs as well now...

10-14-2009, 08:15 PM	#17
Kioshi Heart Up! Vitz Drives: トヨタ Vitz Join Date: Jun 2007 Location: Fremont, CA Posts: 2,582	I'll go ahead and do that. But chances of finding someone with an 08 without ABS is slim to none, at least for me in California.. :( I called my Toyota dealership today and they said they cannot install ABS on my car. Supposedly it comes from the factory installed... So I'm shit out of luck if ABS is required CTScott.... Update 3: SO i had a passenger sitting in my car and the airbag light indicator near the right side vent DOES turn on, but seatbelt indicator does NOT...thats fine for me...no more beep noise~ Do you know of anyone around you w/ an 08 non-ABS yaris lb CTScott? I could ship it out to you, me paying the expenses both ways...