|
07-25-2010, 06:09 PM | #37 | |
Quote:
If it is a bolt problem I was thinking of removing, applying some hardcore locktite and retorqueing the bolts to spec or with in a reasonable range (I don't know what that range is rite now). |
||
07-25-2010, 11:12 PM | #38 |
daily driver
|
nh3r717, sounds like its likely the swaybar endlink....tighten the nut at either end...
if you jack up the car and one is loose, itll clunk as it slides in the hole, but nothing will appear loose when the suspension sags all the way down... you can see the top of the endlink attached to the left side of the strut in this picture....
__________________
|
07-26-2010, 01:43 PM | #39 |
DAT'S RIGHT I GOTz 2
|
yes it does
E.P.S electric power-assist steering any car owners should really read their owners manual and learn to appreciate the workings of their car
__________________
|
07-30-2010, 01:16 PM | #40 | |
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Clicking Noise while Turning | Bella | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 10 | 06-12-2010 01:13 AM |
2006 Yaris clicking/clunking when turning | heistp | General Yaris / Vitz Discussion | 1 | 10-13-2009 09:48 AM |
Humming noise when turning the steering wheel!! Help?? | mhkritzinger | DIY / Maintenance / Service | 7 | 09-28-2009 08:27 AM |
Noise when turning | acuraphile | DIY / Maintenance / Service | 3 | 07-22-2009 02:25 PM |
Side Turning Signal | ttufrosty | DIY / Maintenance / Service | 25 | 08-29-2007 01:33 PM |