|
08-25-2013, 12:17 AM | #1 |
Yoshi 2.0
Drives: 2007 Manual Sedan Join Date: Jun 2013
Location: NC
Posts: 32
|
$15 Fog Lights DIY
Disclaimer!!! I have not tested this long term so do it at your own risk. Read entire thread before deciding to do this.
Materials required:
Click here for photos 1) Remove the bumper and take off the panels where the foglights would be. Be careful not to break the clips holding these panels on; the bulbs will be mounted to this. There are instructions to remove the bumper somewhere else on this forum. Use the next steps for each of the panels. 2) Prepare the holesaw for use. Find the most centered location on the foglight panel and drill/cut the hole. Debur the edges if you want, I didn't because I wanted a rough surface for the silicone to adhere to. 3) Apply a bead of silicone to the lip on the bulb, then place the bulb into the hole you cut. Set it up on a level surface without letting the bulb get pushed out. Allow to dry for about 3 hours, or until it is not runny. 4) Once it is dry enough to touch, apply a generous bead of silicone to the backside of the panel. Again, set on a level surface and allow to dry for about 3 hours before touching again. Recommended cure time for the silicone is 24 hours. To be safe I would not drive with these installed until the silicone is fully cured. 5) Get the length of wire you need (based on preferred hook up) and solder the wires to the back of the bulbs. Put silicone over any bare metal where you soldered the wires to prevent any shorting. 6) When you are ready, install the foglight panels the same way you took them off. **The wiring process I used may not be preferred by some. In this case, there are plenty of other ways to wire them.** When I put my aftermarket headlights in, the connectors were heavily corroded so I soldered new ones on. This is where I soldered the wires for my foglights, this way I didn't need to cut any other wires. Last edited by willisjm193; 08-25-2013 at 11:30 PM. Reason: Adding Photos |
08-25-2013, 08:14 AM | #2 |
Drives: 09 yaris hb Join Date: Jul 2010
Location: qld
Posts: 93
|
photos pls
|
08-25-2013, 09:44 AM | #3 |
Drives: 07 Yaris Liftback Join Date: Nov 2010
Location: Bay Area
Posts: 147
|
Hey, I've always pondered at the idea of doing this but with some Morimoto mini H1 projectors and a 3000k HID bulb kit. But the main obstacle was always those pesky pebbles that'll inevitably fly into the housing causing it to crack and break.
Would the projector retrofit work with a fog light kit? |
08-25-2013, 11:23 PM | #4 | |
Yoshi 2.0
Drives: 2007 Manual Sedan Join Date: Jun 2013
Location: NC
Posts: 32
|
Link is now in first post
Quote:
|
|
08-28-2013, 05:25 AM | #5 |
Drives: 09 yaris hb Join Date: Jul 2010
Location: qld
Posts: 93
|
Ahh nice! I did the same thing on one of my previous cars.
They lasted ages but a problem is when water hits the glass/plastic cover at the front cos they can heat up while on |
08-28-2013, 12:10 PM | #6 |
Ruler of the free world
Drives: 09 Yaris 2D HB Join Date: Jul 2010
Location: Utah
Posts: 49
|
Can the panels be removed without removing the bumper?
|
08-28-2013, 12:29 PM | #7 |
ULTIMATE
Drives: 07 Yaris Turbo Join Date: May 2007
Location: Canoga Park, CA
Posts: 14,859
|
^ You can get to them if you remove the plastic underpanel and/or fender liner pieces.
__________________
Micro Image forums, online store and shop are now closed. It was a great eight year run, but it was time to focus on other things. I'm still selling parts on eBay under micro*image seller ID and customers can still make requests for anything specific. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY (08' USDM Liftback): ESUSE Fog Light Install v2.0 | goku87 | DIY / Maintenance / Service | 127 | 02-19-2023 07:01 PM |
DIY fog lights question! | T Pexx | Cosmetic Modifications (Exterior/Interior) | 7 | 05-05-2011 07:54 PM |
DIY Ebay Projector Fog Lights? | advocate | DIY / Maintenance / Service | 4 | 10-30-2010 01:23 PM |
Fog LIGHTS DIY | blacks | DIY / Maintenance / Service | 2 | 09-28-2010 07:57 AM |
DIY needed for sedan ebay fog lights. | YarisSedan | DIY / Maintenance / Service | 0 | 11-16-2009 05:19 PM |