|
01-04-2018, 03:28 AM | #1 |
I've made a post!
Drives: Yaris Join Date: Jan 2018
Location: Sweden
Posts: 1
|
Help with finding a firewall for amp power cable
Hello i have a yaris d-4d 2008 and i cant find a Good firewall or a hole where i can drag the amp power cable from battery.
Any suggestions or pictures on where to drag it? |
01-04-2018, 09:20 PM | #2 |
Drives: 2015 Yaris Coupe Join Date: Jun 2012
Location: NY
Posts: 43
|
look toward the left closer to the top. There is a rubber plug. Pop it out and snake through.You will have to remove the glove box. squeeze together. pull out. be careful and make sure your power cable has an in line fuse and make a good ground for your amp and yur good 2 go.
|
01-04-2018, 10:30 PM | #3 |
Drives: '08 2zr swapped Vios M/T Join Date: Oct 2012
Location: Caledonia Ont.
Posts: 2,938
|
On the left side at the top of the firewall is a large grommet about 1 1/2" in diameter you can use. For us NA spec'd yaris' it is behind the battery. Not sure if your battery placement is different
__________________
No one ever wants to give a Yaris the point by... |
03-12-2019, 10:31 PM | #4 |
Drives: 2015 Yaris Liftback LE auto Join Date: Mar 2019
Location: Michigan
Posts: 30
|
Hello is this in the same spot on the 3rd gen model 2015?
|
03-13-2019, 03:57 PM | #5 |
Drives: Toyota Yaris RS 2011 (HB) Join Date: Sep 2016
Location: Gatineau (Ottawa), Canada
Posts: 33
|
On both my 09 and 11 HB I got through the firewall on the passenger side from the interior by removing handglove box and panel below it and detaching the carpet from its highest position. To undo the clip attaching the carpet just take a flathead screwdriver and pop the middle of the clip. Find the black rubber grommet, make a X cut in the carpet in front of the grommet to get your wire trough. Remove the entire grommet and if you have big wire, cut the center with a knife and keep only the rubber"ring". If you have a tiny wire, take a drill and make small hole in the center without cutting it. Get wire trough ring and put ring back in the firewall hole. Use silicone if not completely sealed.
|
03-14-2019, 02:57 PM | #6 |
2ZR swap. DO IT! Ask how!
Drives: 09 Meteoric Metallic HB Join Date: Feb 2011
Location: West Michigan
Posts: 2,333
|
|
09-29-2019, 12:21 PM | #7 |
Drives: yaris d4d 2013 Join Date: Sep 2019
Location: Greece
Posts: 4
|
I have a 2013 d4d and i really can't find the firewall, anoyne has photos? Thank you.
|
09-30-2019, 09:00 AM | #8 |
2ZR swap. DO IT! Ask how!
Drives: 09 Meteoric Metallic HB Join Date: Feb 2011
Location: West Michigan
Posts: 2,333
|
The firewall is the panel that divides the passenger compartment from the engine compartment. The hole we're talking about is about 2 cm in diameter and has a rubber plug in it. It's behind the wiper cowl, above the ECM, almost up to the windshield. You might have to remove a few parts to be able to reach it--wiper arms, wiper cowl, wiper tray. The hood can probably stay in place even though the repair manual says you should remove it for accessing that area.
You can also see it from under the dashboard but you have to remove the glovebox and peel back the padding a little bit at the top. |
09-30-2019, 04:22 PM | #9 |
Drives: yaris d4d 2013 Join Date: Sep 2019
Location: Greece
Posts: 4
|
Thank you very much, my sub and amp arrived today and i was stressed about it, i know what it is but i couldn't find it, i will look for it tomorrow, thank you very much.
|
10-02-2019, 06:04 AM | #10 |
Drives: yaris d4d 2013 Join Date: Sep 2019
Location: Greece
Posts: 4
|
This is a photo behind the glovebox, where is the spot i have to peel off because it seems hard to do it so I have to cut it.
https://ibb.co/YyKG4dr |
06-15-2021, 02:24 PM | #11 |
Drives: Yaris SE 5dr 2016 AT Blue Join Date: May 2020
Location: Montreal
Posts: 6
|
Follow
im at that place too i wonder what is the pink plastic pin and where it go. the clear tube is windsheild washer for back glass but it seem to go behind the shock tower not acces.. I want to know if i drill out a hole bettween the pink clip and clear hose where its gonna be in the engin bay cuz there some place to put decent seal tight connector.
|
Tags |
amp, amplifer |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
When will the Yaris hit the showrooms at dealers? | Petrolhead | New YARIS Purchase Forum | 181 | 11-28-2011 07:03 AM |
Running Firewall Power Wires for subwoofer | MacMaster761 | In Car Entertainment + Electronics (audio / video / alarm) | 17 | 03-06-2010 03:04 PM |
Well seems the F&*king Power Package with Manual is impossible in the States(Hatch) | gaffo | General Yaris / Vitz Discussion | 28 | 07-15-2007 07:55 PM |
Need Help - Electrical (finding Power) | Ayka | DIY / Maintenance / Service | 7 | 10-12-2006 11:51 AM |
using regular power lock kits with cable style | twixt | DIY / Maintenance / Service | 4 | 08-12-2006 01:18 PM |