|
10-08-2019, 03:23 PM | #19 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
Then put pump pulley then alternator on. Final tightening pump pulley with by on. I will ass a few more pics later .
|
10-08-2019, 05:56 PM | #20 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
Photos of how to pry alternator . Pry alternator til it hits adjustment mark made with a Milwaukee jobsite marker. Tighten 12 mm bolt with right hand while holding pry bar/ alternator in place with left hand. Pry off motor mount as shown
|
10-08-2019, 05:58 PM | #21 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
12mm Wright ratcheting wrench on alternator tensioner
|
10-08-2019, 06:03 PM | #22 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
Torque specs : 14 lb ft alternator tensioner
40lb ft alternator bottom bolt 11nm 97 inch lbs water pump bolts/nuts 13nm 115 inch lbs water pump pulley bolts 9nm. 80 Inch lbs thermostat housing |
10-08-2019, 06:23 PM | #23 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
Couldn’t fit a torque wrench even with a crows foot or torque adapter on water pump pulley . Tightened with a 0 offset hazet 10x11 TIL pulley moved and slipped belt .
|
10-08-2019, 09:37 PM | #24 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
The gasket scrapers. A razor blade at 90 or a SK gasket scraper with my thumb on top so it stays flat .
|
10-08-2019, 09:43 PM | #25 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
I replaced factory hose clamp with a work drive clamp. It was hard to get back on thermostat housing even when compressed all the way with hose clamp pliers .
|
10-08-2019, 09:46 PM | #26 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
I used a asin water pump and gasket. Genuine Toyota thermostat o ring. Stant thermostat . Had alternator rebuilt at chestnut hill electric for $108. It got new brushes , bearing and voltage regulator.
|
10-08-2019, 10:22 PM | #27 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
10mm deep socket , 1/4 drive tekton ratchet negative battery terminal
|
10-09-2019, 10:50 AM | #28 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
Due to close proximity of fender, it takes some maneuvering to get alternator and water pump in and out but definitely doable.
|
10-09-2019, 03:02 PM | #29 |
This looks like quite a bit of work! Gosh I miss my old Skoda 105, I could change this in 5 minutes there!
|
|
10-09-2019, 03:44 PM | #30 |
Drives: Olive yaris,FRS, Dakota R/T Join Date: Aug 2013
Location: Pa
Posts: 147
|
Wasn’t too bad. Had to finagle water pump and alternator in and out. Thin head ratchets helped a lot. It was very hard to keep socket on lowest water pump bolt when torquing to spec. Plus it was a pain scraping the minimal rubber gasket residue off due to tight quarters .
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water pump replacement guide? | Mrb | DIY / Maintenance / Service | 5 | 02-05-2019 01:05 PM |
Odd Fuel pump issue. Feeling at a loss. | Marchalis | DIY / Maintenance / Service | 4 | 03-06-2018 08:55 PM |
Location of Water Pump | lululovesu | DIY / Maintenance / Service | 1 | 10-19-2014 08:05 AM |
drive belt replacement and/or water pump replacement | sociolog | DIY / Maintenance / Service | 9 | 02-10-2014 12:33 PM |
Rear Shocks Replacement? Water Pump. | babytic | DIY / Maintenance / Service | 7 | 06-15-2013 03:55 PM |