Cruise Control on 2010 Canadian Manual

[Kaya B.]

Originally Posted by CTScott

Check out the link below. This Belgium based company makes an aftermarket CC for European Toyotas:

http://www.el-pas.com/products.htm

thank you. I've sent mail to them.

Also, I'm talking with the authorized dealer. they say they can make...

[CTScott]

Originally Posted by henry33

where or how you check this ?

I have copies of the US, European, Asian, and general market electronic parts catalogs. They have the ability to decode the VIN and give the details on the car.

[Kaya B.]

my cruise buttons arrived.

i don't know if it will work. the authorized service says we'll try :)

is this the right buttons? the right connector?

and it has a wire at the back of it. is it normal so is this original?

i bought it from ebay as "brand new oem" at this item http://cgi.ebay.com/ebaymotors/TOYOT...Q5fAccessories

[CTScott]

It's the correct stalk, but it won't work on your car...

[Kaya B.]

Originally Posted by CTScott

It's the correct stalk, but it won't work on your car...

Thank you Scott. I'll just try. because if it doesn't work i won't pay for other parts. But if it works i have to pay about 100$ so I need some time :)

I will give you info. Thanks for your helps.

[CTScott]

Originally Posted by Kaya B.

Thank you Scott. I'll just try. because if it doesn't work i won't pay for other parts. But if it works i have to pay about 100$ so I need some time :)

I will give you info. Thanks for your helps.

Start by measuring the voltage on pin 40 of connector A21 on the ECM, with the ignition on, but the engine off. If it measures 12 V, then it it worth a shot, if it doesn't, then stop there.

[Kaya B.]

Originally Posted by CTScott

Start by measuring the voltage on pin 40 of connector A21 on the ECM, with the ignition on, but the engine off. If it measures 12 V, then it it worth a shot, if it doesn't, then stop there.

thank you. i'll try this.

[CTScott]

Since you are willing to experiment and put some money into trying to get cruise control on your car, another option, which I believe will work on the European Yaris, is the Rostra aftermarket cruise control kit.

It is quite a bit more work to install, but it overrides the gas pedal signal itself, rather than requiring that the ECM do that. The European Yaris uses the same 6 pin connector on the accelerator pedal, with the same pinout as the US one, which is why I think that this should work.

There are two versions for the Yaris - An A/T kit ($209) and an M/T kit ($249)
http://www.thecruisecontrolstore.com...g/X380183/0003