DIY: 2006-2011 Yaris OEM Cruise Control Complete Installation

[sh0rtlife]

the link in the post above yours is still good...

[matt4x4]

Nice that I found this, looks easy enough.
Long road trips the cruise on my '08 manual, sedan w/power will come in handy, just worried about any loss of power on the hills with the 1.5L, drove a bit into the mtns through the hwy1 hills a little bit into the rockies (Banff/Nakiska/back road hwy 40) back to the big city, and I had to downshift sometimes, just day 3 driving the cutie Yaris. I still need to fine tune the rpm gear change on the manual, I go by sound of rpms, but am in it for fuel sipping.



Link worked for me
Thanks

[sh0rtlife]

i know with an auto running the coastal range it will downshift and handle it just fine..with a manual your kinda on your own there as to wen to downshift and pop out of cruise

[hypersata]

Hello there,

can anyone help me with the Aftermarket kit for Yaris 2014 GCC - Cruise control?
I cant find something useful on the internet myself.

as I discover from this forum, GCC versions are not supporting OEM CC.

any help would be much-appreciated Folks.

For the reference
NCP151L-CEPRKV
MHFBW9F36F50027xx
2NZFE 1300CC 16-VALVE DOHC EFI

[En4sir]

I have a 2009 Yaris 2 door hatchback with a 5-speed trans. It has factory installed cruise control and 332,000 miles on the odometer. The cruise control recently stopped working. I've tried to activate the CC however the yellow CC light in the instrument cluster does not illuminate, nor will the CC operate. Hoping the culprit was a blown fuse I inspected all fuses - all seem fine. Then, hoping it was the CC stalk (hoped that the switch wore-out) I replaced the stalk with a brand new OEM stalk #84632-08021 Speed Control Switch. The CC still doesn't operate. I checked the original stalk with a multi-meter and the original stalk has continuous power while the stalk button is kept pressed in, but as soon as I remove all pressure off the button continuous power is disconnected. I assume that's how the on/off button in the stalk is supposed to operate(?).

I'd really like to get the CC operational again. What should be next course of action? I suspect that even if either CC disengage switch on the clutch and brake pedals are faulty, the CC indicator light on the instrument cluster would still light up. Is there a relay that powers the CC? Again, the yellow CC indicator light on the center instrument cluster does not illuminate. Other than the CC not being functional, everything else works flawlessly. Bad relay? Bad ECM? Or?...... Any advice that you may provide to restore my CC is greatly appreciated.

[sh0rtlife]

10-1 odds are its your snail AKA spiral cable, its actualy one of the hardest wearing parts on a car as your basicly bending wires back n forth every time you turn the wheel

9-10 times when a FACTORY CC fails it can be traced to 1 of 2 things, a bad spiral cable or a bad brake switch..and before you go and check if your brake lights work..remember that it has a secondary set of wires on the switch SPECIFIC to the cruise and not part of the brake lights

yet the first thing anyone replaces is the cruise stalk thinking its that....belive it or not ive yet to find one dead that wasnt physically visually damaged on the outside...fun side note is that said switch sometimes replacing it with other bad parts will give a false positive and youll have working cruise for a single use...its because you got lucky...i chased that demon earlier this year on an XB..intermitent CC working..was a combo of the spiral AND the brake switch both were intermitently bad

[nickshch]

I have installed just the Cruise Control Switch to my Toyota Yaris 2011 Liftback AT (made in Japan, for US market) and that worked. Amazing! Thank you very much guys. Bought it on Amazon for $15

[steelwheels]

kevinj93 thank you so much for uploading the manual to google drive and sharing it on this forum I will now be installing CC in my '10 2dr mt hatch!! seems like all I need to buy is the clutch switch and the stalk. amazing.

here is the link to the file again just to make it super easy to find:

https://drive.google.com/file/d/1Bfc...fZXIDu7wL/view

[CrimsonEclipse]

Finally finally FINALLY getting to the CC mod

Looking at the install guide, it seems to imply that my 2011 M/T doesn't need wiring installed. Looks like it already has a clutch switch installed, and it seems that all I need to do is install the stalk.

Does that sound right?

(would be great if I can do this for $35)

[Gemak]

I have AT and followed the guides in this thread and now I have CC. Go for it, just be careful with the air bag