Quote:
Originally Posted by RedRide
As the problem is, not enough of the hole is revealed to insert the pin, the soulution was to taper the end of the pin with a file to get it started.
However, this did not work and I still can't get it installed.
I might wind up modifying the SS with my dremel.
BTW, the cause if this is, athough the SS is a precision machined part, the shift arm and pin isn't and can vary is size sometimes.
|
Are you 100% sure on that
You and me seem to be the only people with this issue and we both have the piggies kit.
09-18-2009, 10:44 PM
Similar Threads
Threaded Mode