 |
 |
|
|
04-13-2020, 10:14 PM
|
#1 |
 Drives: Yaris 2007 Hatch Join Date: Apr 2018
Location: North America
Posts: 10
|
CV Axle replacement.
Hi guys,
My drivers side boot has split pretty badly, and I want to change the axle out. The service manual has you remove the stabilizer link, lower ball joint and tie rod to get the wheel free. Can you not simply zip out the 2 bolts that connect the knuckle to the strut, and remove the axle that way? If I was getting an alignment anyhow, could I do that, or would I still need to separate the ball joints? I'm trying to avoid doing them and the stabilizer link because they're rusted to hell. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TRD Delrin Rear Axle Bushing Collars | tmontague | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 4 | 12-15-2019 07:50 PM |
| Wheel bearing / Outer TRE / Control Arm replacement howto | shepd | DIY / Maintenance / Service | 3 | 09-14-2015 04:20 PM |
| Request: Picture of the transmission end of passenger CV axle | WildChild | DIY / Maintenance / Service | 2 | 06-16-2014 12:35 PM |
| Wheel Bearing Replacement (FRONT) | justjesus | DIY / Maintenance / Service | 11 | 04-26-2014 07:38 PM |
| drive belt replacement and/or water pump replacement | sociolog | DIY / Maintenance / Service | 9 | 02-10-2014 12:33 PM |
Threaded Mode