Wires Inside the Yaris & What They Do

[CTScott]

Originally Posted by fase4

hi! If I want to turn something on with the flash or high beams od the headlight, were I had to connect the + and - wires of my 12v circuit? I wanna do this because I want to open my garage goor with the opener activated when I flash my headlights.

Maybe I have to tap de + with the Pin 9 and the - at the Pin 11?

If you have a 2005, then yours is a fist gen, so the headlight wiring will be different than the second gen connector pictured.

For the first gen, the red wire with the yellow strip in pin 9 is the high beam wire from the switch. That wire gets switched to ground when the high beams are flashed, so you would use pin 9 as your switched ground wire.

You would want to use a relay that you switch the coil of with that wire, and then use the normally open relay contacts to trigger your garage door opener's switch.

[Rudra223]

where is the reverse light wire?
and what is the colour?

[Rammy]

Where is this whole piece as seen in post 14?
I want to wire some door sills and have them light up when the door opens up. I usually keep the light in the off position and not on the "door" position. So if I want it to work the way I want it to, am I going to have to keep the switch on "door"? This might be the wrong thread but I was redirected by Scott on another thread. Thanks!

[CTScott]

Originally Posted by Rammy

Where is this whole piece as seen in post 14?
I want to wire some door sills and have them light up when the door opens up. I usually keep the light in the off position and not on the "door" position. So if I want it to work the way I want it to, am I going to have to keep the switch on "door"? This might be the wrong thread but I was redirected by Scott on another thread. Thanks!

Behind the little storage cup on the bottom left side of the dash.

[Rammy]

Oh ok! Thanks.
And where can I tap into the parking lights? The lights that turn on when you twist the switch half way. I am also installing some LEDs for the interior and I want them to turn on w/ the parking lights. And do any of you recommend the "L bars" or just regular LED clusters? I want them to go under the whole dash kind of where your feet go.

[CTScott]

Originally Posted by Rammy

Oh ok! Thanks.
And where can I tap into the parking lights? The lights that turn on when you twist the switch half way. I am also installing some LEDs for the interior and I want them to turn on w/ the parking lights. And do any of you recommend the "L bars" or just regular LED clusters? I want them to go under the whole dash kind of where your feet go.

See my remote start wiring DIY for the parking light connection:

http://www.yarisworld.com/forums/showthread.php?t=24860

[rhendy87]

Hi guys,

im new to the forum here.i am trying to install a yaris smart entry and remote start.i have a few wiring question such as follow :

1.Oil circuit detection
2.hand brake
3.cut oil and electric circuit off
4.door detection
5.windows regulating control

for Yaris central locking wiring.what type of wiring is it?is it negative triggering or possitive triggering?

btw my yaris 2010 5 door hatchback.

i will really appreciate if someone can help me here.

regards,

Rhendy

[rhendy87]

by any chance..any1 can help me?

[CTScott]

I thought your post might have been spam with odd combination you were asking about, but since you sent me a PM with some specific questions, it seems like you are not a spammer.

In your PM you mentioned that you found all except these two:

1.Oil circuit detection
2.Cut oil and electric circuit off.

For #1, the Yaris has an oil pressure switch that is located on the front of the block about 6 inches above the oil filter. It has a single yellow wire (since its case is grounded to the block). That yellow wire is only an input to the instrument cluster for the warning light.

For #2, I am not sure what you are looking for. The only circuit associated with oil is that simple oil pressure switch.

[rhendy87]

[IMG]

[IMG] Uploaded with ImageShack.us[/IMG]

thank you so much scott for replying..

i've attached the wiring diagram i received from the maker.

the information i received for the"oil circuit detection"wiring has got to do with the fuel pump wiring.it is added as a security feature in anycase if somebody try to breakin in the car without authenticating the wirelesskey(force breakin).The engine wont start.it has something to do with shutting the car off.

i think that in this case is not oil but fuel.

[CTScott]

OK - That makes more sense for it to be the fuel cut-off. Sometimes the directions seriously lose something in translation.

In that case, you are interested in the violet wire on Pin 7 of the smaller ECM connector.

[rhendy87]

the Y&W wire goes to Violet wire.
how about the Y&GN wire?where do i connect that wire?

or do i connect both wires to violet?

i read in your DIY Cruise control thread.A21 pin is located in the engine bay.is there any other location easier to access to fuel cut off?




i am speculating based on your pictures.is that the correct violet wire?

[CTScott]

I would need to see a better explanation of the module. In theory there should be two wires - in and out, so the device can interrupt the fuel pump feed.

[rhendy87]

i manage to get the smart entry working well and fine with no problem.haha..

i take the fuel pump wiring from under the car seat.

thanks scott for helping out.

[fase4]

regarding to colors, I cannot rely
lol

Mines is a european base model so maybe for that the colors difference

Ok I get it about the pin 9. So I tap here the - right? what about the + connection? Also the relay for what would serve?

sorry for the question but I know almost nothing about this

[yelcur]

please send full detail on toyota yaris sedan year 2008. .front totally damaged in accident .if someone selling parts let me know..! wiring system completely damaged.

[bonnorano]

Hello everybody i missing a dimmer switch on my indonesian/thailand yaris 2012 5doors, i want to add tachometer on my yaris. Please help me :(

[CTScott]

Originally Posted by bonnorano

Hello everybody i missing a dimmer switch on my indonesian/thailand yaris 2012 5doors, i want to add tachometer on my yaris. Please help me :(

The Asian market Yaris do not have the dimmer rheostat. You can either just use ignition switched power for the tachometer illumination wire of you can use the illumination wire on the radio.