 |
 |
|
|
|
|
|
|
||||||||
 |
|
|
Thread Tools | Display Modes |
12-17-2013, 07:47 PM
|
#1 |
 Drives: sedan Join Date: Jun 2010
Location: toronto
Posts: 27
|
Potential purchase .. Bumper to hood gap slightly larger on drivers side... ????
Looking at making the deal but am concerned a little about the hood gap. Are the bumpers adjustable and how are they adjusted? The car has a few bumps and scrapes and I'm sure it was bumped in the front a little to cause it I'm just hoping I can adjust it back to stock easily. I'll put a pic up shortly.
Thanks ! 
|
|
|
|
12-17-2013, 08:00 PM
|
#2 |
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
The bumper to fender mounting looks good, so the issue is just with that corner of the hood. There is a rubber bumper on either side of the radiator support that bumper sits on. They are adjustable (you can turn them to make them raise or lower). It looks like the driver's side one might be too high.
__________________
|
|
|
|
|
12-17-2013, 08:12 PM
|
#3 |
|
Drives: sedan Join Date: Jun 2010
Location: toronto
Posts: 27
|
Thanks for the reply ! Never thought about the hood just being a little up looked like the gap was from the bumper being pulled away from it.
|
|
|
|
|
12-17-2013, 09:34 PM
|
#4 |
|
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
The bumper looks good, even from the front. I really think it is just the hood.
__________________
|
|
|
|
|
12-18-2013, 01:32 PM
|
#5 |
|
Drives: sedan Join Date: Jun 2010
Location: toronto
Posts: 27
|
Took a peek at my wife's yaris last night and I see the 2 rubber bumps with a slot to raise /lower. Thanks I hope that's all that's wrong !
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Zage Turbo Kit Install - Toyota Yaris | Focus_Sh1ft | Forced Induction Forum | 160 | 02-06-2022 08:14 PM |
Linear Mode
