DIY Rear lower sway bar for mk2

[Compeer]

heya guys, so i realize the rear lower sway bar by most comapnies is just two drilled plates and a piece of bar.

We can make this with some 2mm steel plate and some 30-40mm steel square bar.

Now you could weld this but you can easily bolt this together too if you only have a drill.

Here is the megan racing brace I will copy, the amount of bolts they are using is overkill, some brace us two but I figured 3 would traigulated would be enough each side. this allows you to use a piece of 2mm x50mm sheets or even cut large steel square bar like i have.



Here is my started brackets, 3 bolts each side and enough room to weld the square bar on the end.



Tomorrow will mig weld it up, paint it and post finished product before taking the car for a good test drive.