 |
 |
|
|
05-18-2022, 09:42 AM
|
#1 |
  Drives: 2009 yaris 2 door Join Date: Feb 2013
Location: richmond TX.
Posts: 232
|
Front hub Axle nut torque process
I know that the torque value is 160 flbs for the front hub Axle nut but was wondering if you stretch the nut first like other vehicles. On some vehicles you go up to 180-200, (that stretches the nut) then come back one complete turn , then torque back to the desired value. Or is this just a strait 160 torque and stake the edge, leave alone?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Front control arm bolt spinning | E34_Guy | DIY / Maintenance / Service | 5 | 06-03-2022 07:14 PM |
| installing Penguin Garage rear hub spacers! | Tamago | DIY / Maintenance / Service | 101 | 05-21-2011 12:29 PM |
| Newly refreshed 2011 Toyota Corolla | Kal-El | Off-topic / Other Cars / Everything else Discussions | 23 | 11-27-2010 12:57 PM |
| I CANNOT get the front strut nut off | naossoan | DIY / Maintenance / Service | 10 | 05-30-2009 03:11 PM |
| Torque Settings, front suspension | Nimble | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 1 | 02-21-2007 01:00 PM |
Threaded Mode