Install Atoto SA102 Starter in Yaris 2007 (XP9)

[Format]

Hello everyone,

I think is a good idea to share my experience with the installation of Atoto SA102 Starter unit in my Yaris 2007 (XP9) (European Car).

List of things that you need to buy:

* Atoto unit (in my case I choose the SA102 Starter unit)
* CTSTY001.2 from connects2
* CTMULTILEAD.2 from connects2
* Yaris frame for install 2Din unit

With this things you can easily install the unit with fully functional steering wheel controls.

In my case I only solder 3 wire, the rest of the wires I use the ISO B connector cable that came with the unit. It was super easy.

In the wires that came with the unit you have 3 wires for steering wheel, that you need to connect to the CTMULTILEAD.2

Steering wheel GND => GND
SW Key => Key 1
SW Key# => Key 2

With this you have the unit fully functional with the steering wheel controls.

1) This is my original yaris unit


2) This is the final result after install the SA102 Starter unit


3) The 2Din frame that I bought


4) The list of things that came with the unit


Has you can see in the picture number 2 I fill the gap of the unit and the frame with a silver bezel that came with the phonocar frame. But when I have a little of time I will try with the black bezel that came with the Atoto unit (see picture 4).

I hope the information that I published help someone to install the Atoto unit.

I also saw a few videos with tutorials works before install the unit. This is the list:

https://youtu.be/ygRz5dzpGR0

https://youtu.be/-kUOZVb8XKU

https://youtu.be/Ja6cLDWXLto

https://youtu.be/r7GlDBge_WU

https://youtu.be/AcqWHIRSaIk

https://youtu.be/aSQTje4sXfs

https://youtu.be/FuSUm9F32hE

https://youtu.be/c-0x05_si58

https://youtu.be/htC2hpzHQ_M

https://youtu.be/vIfZQd0wpg4

https://youtu.be/PAUm17NNXPM

https://youtu.be/o1gqoGeyMeY