|
02-05-2014, 02:07 PM | #1 |
Drives: 2008 Yaris Join Date: Jan 2014
Location: Union Mills, NC
Posts: 20
|
New question evap canister replacement
Ignore my old thread below as I have updated it.
Bought me a used evap canister and installed it. Thanks so much for the help with the connections. Was not difficult once I knew how to get them apart. After about 180 miles my check engine light came on and I went by Advanced Auto to see what code had come up. It read a small evap leak. I reset it and drove another 300 miles and the check engine came on again, same code P0456 small evap leak. I also still have a problem where I cannot pump gas very fast when I fill it up. It seems like it is not able to relieve the air as quick as I am putting the gas in. When I took the old evap canister off I checked the filter box? in the line from the evap canister to the filler neck. I did not remove it but I disconnected both lines leading into it and attached some tubing so I could blow through from each direction to make sure there was no water in it. I shook it and did not hear anything. Did not see any moisture but it seemed like there was some restriction in it. I figure it may only pass air/fumes in one direction but it was difficult to get air through either way. Could this cause the problem with not being able to pump gas at a normal rate or may I still have an issue with the evap canister? It did pass the emission test here in NC when the light was off. |
02-05-2014, 02:46 PM | #2 |
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
The air vent pipe that goes to the filler neck should pass air without a problem in both directions. If is does not, their may be a spider web or something like that partially blocking it.
__________________
|
02-06-2014, 01:01 PM | #3 |
Drives: 2008 Yaris Join Date: Jan 2014
Location: Union Mills, NC
Posts: 20
|
Thanks!
Must be a big spiderSeems like alot of restriction in that little plastic box. I have a real problem with mice but I don't know how he would got in there. The little beggers have chewed every wire on my ignition switch for my kawasaki mule. I finally wrapped the wiring harness with double sided tape coated with black pepper. They don't like thatThansk for the help! |
02-06-2014, 01:16 PM | #4 | |
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
Quote:
__________________
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Need help with Evap Canister Replacement | Rutherford | DIY / Maintenance / Service | 8 | 02-04-2014 10:59 AM |
EVAP canister | Jason@SportsCar | Items for Sale by private party | 5 | 04-11-2012 01:04 PM |
Selling my Yaris - Clutch Replacement Question | Swoleslaw | DIY / Maintenance / Service | 9 | 11-05-2011 11:27 AM |
replacement bulb question | justinparadise21 | Cosmetic Modifications (Exterior/Interior) | 2 | 11-06-2008 01:52 AM |