oem tweeter a-pilliar removal - Toyota Yaris Forums

adio51 · 07-04-2012, 01:48 AM

has any one with a 2012, removed the a-pilliar to access the oem tweeter.

muffin_top · 07-04-2012, 11:01 PM

Yes.

There are two clips holding the pillar to the body. The center clip is standard round style used all over the car. The upper clip is special in that it is designed to hold the pillar in the event the curtain bag deploys.

Pull the trim from behind the weatherstrip toward the center of the car. When it pops loose you can see the upper clip holding it about 1.5 inches from the body. The clip rotates so that the end holding the trim can pulled through its opening thereby allowing it to be removed. It's best to use a needle nose pliers to rotate the clip as reaching it with your fingers will be difficult.

07-04-2012, 01:48 AM	#1
adio51 Drives: 2012 Toyota Yaris SE Join Date: Dec 2011 Location: Colorado Springs Colorado Posts: 6	oem tweeter a-pilliar removal has any one with a 2012, removed the a-pilliar to access the oem tweeter.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OEM tweeter wiring on UK Yaris	Paul Evans	In Car Entertainment + Electronics (audio / video / alarm)	3	04-23-2012 01:47 PM
Ultimate yaris part out, aftermarket and OEM	yaris rs	Items for Sale by private party	25	06-20-2011 12:43 PM
OEM Parts	hatchbackkid82	Items for Sale by private party	30	12-17-2009 10:08 AM
FS: OEM STUFF	darkmoon87	Items for Sale by private party	2	05-29-2009 05:21 AM

07-04-2012, 11:01 PM	#2
muffin_top Drives: 2012 Yaris SE 5MT Join Date: May 2012 Location: Midwest Posts: 103	Yes. There are two clips holding the pillar to the body. The center clip is standard round style used all over the car. The upper clip is special in that it is designed to hold the pillar in the event the curtain bag deploys. Pull the trim from behind the weatherstrip toward the center of the car. When it pops loose you can see the upper clip holding it about 1.5 inches from the body. The clip rotates so that the end holding the trim can pulled through its opening thereby allowing it to be removed. It's best to use a needle nose pliers to rotate the clip as reaching it with your fingers will be difficult.