DIY Cruise Control for 2012 Yaris - Good News!

[DarkShadowFox]

I put in a call to my service advisor because it dawned on me that possibly it didn’t get wired from the factory by mistake. I’ll follow up and advise as to what I find out.

i wonder if its a thing that gets prewired with the power mirrors.

hey i found your guide

https://www.youtube.com/watch?v=vLyRH5eSpps

[Captain Yaris]

Just an update: I was told by my service advisor that they are not willing to help, install, or sell parts pertaining to installing cruise control. Apparently they are spooked because of the past law suits that had to do with the stuck accelerators.

[Captain Yaris]

Got it figured out, and now it’s alive!!!!!!!!!! I had to swap a wire that was just a plug with a ground with a different wire that included the ground and connection to the cruise control unit. A special thanks to DarkShadowFox for hyperlinking that video of the Rostra install. It gave me the idea to pursue the correct wire from Toyota. Thanks for the help.

Part numbers to install on US Spec 2016 Yaris L are as follows:

Cruise Control Switch (84632-08021)
Clutch Switch; for cars with manual trans. (8820-42010)
Steering Wheel Switch Cover (45186-0D150-C0)
Cruise Switch Wire (84633-02020)
Cruise Control Switch Screws; need 2 of these. (90159-50199)

[DarkShadowFox]

Got it figured out, and now it’s alive!!!!!!!!!! I had to swap a wire that was just a plug with a ground with a different wire that included the ground and connection to the cruise control unit. A special thanks to DarkShadowFox for hyperlinking that video of the Rostra install. It gave me the idea to pursue the correct wire from Toyota. Thanks for the help.

Part numbers to install on US Spec 2016 Yaris L are as follows:

Cruise Control Switch (84632-08021)
Clutch Switch; for cars with manual trans. (8820-42010)
Steering Wheel Switch Cover (45186-0D150-C0)
Cruise Switch Wire (84633-02020)
Cruise Control Switch Screws; need 2 of these. (90159-50199)

LMAO JFC dont tell me even the L gauge cluster has a spot for the cruise control omfg. they are ripping people off on these yarises lmao.

[Captain Yaris]

LMAO JFC dont tell me even the L gauge cluster has a spot for the cruise control omfg. they are ripping people off on these yarises lmao.

It sure as hell does!

[Dodge Aries K]

Your dealer person is crabby apparently. The dealer I bought my 2016 Yaris L from actually gave me the clutch switch and installed it for me after I showed them I plugged in the factory switch from another car into the steering wheel and that it lit up on the dash. The service adviser wanted to see if it would actually work hahaha.

[Captain Yaris]

I remember that! That’s why I wouldn’t give up, I know it’s been done before. My dealer deals with a lot of little old ladies buying Corolla’s, Camry’s, and Rav4’s. They just sell the higher package and could care less about modding.

[DarkShadowFox]

It sure as hell does!

DUMMM. o well i wanted power locks and the rear lock squishy panel vs a manual lock and im not going to be the one to make a thread on how to install that. thats more money then you save on buying an L .

[ern-diz]

I hope CTScott is well.

[NYC-SE]

I hope CTScott is well.

Me too.

[Captain Yaris]

Is he not ok? I haven’t seen him on here in awhile.

[WeeYari]

He's been on, just not posting.

Sent from my Elite_5_5_Octa using Tapatalk

[irakli_86]

I've just installed the cruise control stalk into my 2012 Yaris with a 1.3 (2NZ) engine. Its automatic and GCC (middle east) spec. Straight plug and play into the 4 pin connector slot which was empty next to the 10 pin connector. Mine has audio buttons as well bluetooth handset buttons. I didn't have to swap any pins whatsoever, cruise light and set all work fine.
Took about 10 minutes including setting up the audio after battery disconnect.
Only thing remaining is for the oem cover with the hole and rubber grommet to arrive.

Thanks to CTScott for all the info in this thread !

[Per Olof]

Hello I´m new at forum,I want to now if my Toyota Yaris is ok for cruise control
the picture is from under the steering next to yellow socket,the 10 pin socket
and if I can buy a set from you Scot

[vigvoodoo]

Cruise Control Switch (84632-08021)
Clutch Switch; for cars with manual trans. (8820-42010)
Steering Wheel Switch Cover (45186-0D150-C0)
Cruise Switch Wire (84633-02020)
Cruise Control Switch Screws; need 2 of these. (90159-50199)

Will this work for:

2016 Toyota Yaris L base model
Automatic
Touchscreen
No steering wheel controls

?

[DarkShadowFox]

Hello I´m new at forum,I want to now if my Toyota Yaris is ok for cruise control
the picture is from under the steering next to yellow socket,the 10 pin socket
and if I can buy a set from you Scot

scot does not sell sets he is not a dealer. you can buy all the parts from the internet. on camelback. he just assembles things.

[Per Olof]

thank you for your ansver,I have look at Rostra and conection to ECM is not possible
Its a diffrent ECM behind the glove compartment,But I found a good universal one at
CANM8 England,It works fine in my car from OBD and can bus,the only thing is that it
dont get brake signal to can bus, but they send me extra conection from the brake padel to cruise module,I have test it already and it works fine without extra adjustment,it has a cruise brake butten on the backside of the stulk

[DarkShadowFox]

Hi everyone,
I have a US Model, 07, M/T, 1.5L, 3 door hatch. I'm installing this CC solution and I'm at the point where I'm running the D3 connector to the ECM pin 40. Please see the pic below. Which wire and pin do I send to the ECM and which one do I ground? The picture of my Yaris is different then the pictures in the instructions from CTScott. Thanks!!

https://share.icloud.com/photos/04lHN3EUNqrah7sf_DqrWtH0A

this is the 2012 forum and up. the changes are different subtle but different.

[Civic_JDM]

Interesting that both of the Greek 1.33 are not working. Can either of you give me the part number of your ECM (engine computer)?
Hello CTScott,

Please help to confirm if ECM # 89661-5C340 (Japnese spec, 1.0L engine i.e. 1KR-FE) support cruise control?

[stykerdk]

Hi
I have yaris 2013 1nr-fe 1.33 engine europe specs and installed the cruise stalk .

The problem is the indicator at the instrument cluster doesn't lit .Otherwise the cruise control works just fine .

Is it possible to fix this problem ?

Which instrument do you have.
If its the basic one without RPM meter it probably also dont have the cruise light.
Then you can switch it to one of these which should have cruise lights, my car has it.
https://www.ebay.de/itm/Toyota-Yaris-III-Tacho-Tachometer-Kombiinstrument-Benziner-220-km-h-83800-0DP60/332884466031?hash=item4d8175d96f:g:qmgAAOSwJQtap80 9:rk:2:pf:0

https://www.ebay.de/itm/Toyota-Yaris-Instrumental-Tachometer-XP130-km-h-Benzin-83800-0dp60-LHD/122997643433?hash=item1ca33b18a9:g:Je4AAOSwmFpZsUT E:rk:36:pf:0

https://www.ebay.de/itm/Tacho-Kombiinstrument-Toyota-Yaris-83800-0DR50-MB157550-5207-838000DR50-MB15755/132349876207?hash=item1ed0aad7ef:g:l7MAAOSwyWlbpqh d

[Civic_JDM]

Dear Experts

Please help to confirm if ECM # 89661-5C340 (Japnese spec, 1.0L engine i.e. 1KR-FE) support cruise control?

[Stargate]

Ciao, have Active Yaris 2018. I can't open for install Cruise control. Can you help me. Thanks

Inviato dal mio ONEPLUS A5010 utilizzando Tapatalk

[stykerdk]

Ciao, have Active Yaris 2018. I can't open for install Cruise control. Can you help me. Thanks

Inviato dal mio ONEPLUS A5010 utilizzando Tapatalk

https://www.youtube.com/watch?v=H8r_oUV_plI

[Spidious]

Been thru this twice. If I have to plug in the cruise wires in the steering wheel connector which and what colors ? I have a 2017 Yaris L

[Immanuel]

Can I install CC on my 2015 Yaris hybrid? Has anyone tried? Can anyone tell me if it will work? Thanks

[storyofakid10]

^Nice!

By the way, I recently acquired a batch of the replacement covers for the side of the 2012-2013 steering wheel, which have the hole for the cruise control stalk. They are $5 shipped in the US.
Hi CTScott, I know this post is now 10 years old, but I am looking to install a CC stalk on my 2012 Toyota Yaris and am wondering if by any chance you are still selling the side steering wheel covers (with cutout for CC stalk) for $5? I am in the US. Thanks

[lancap]

Hi,

May someone help me, already sent a post, and had some help, but Am stuck.

( Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Technical Forums > DIY / Maintenance / Service
2014 Yaris Cruise Control - No Success )

I have this Yaris:
NLP130L-CHFNXW (2014 European Model MT)
ENGINE: 1NDTV 1400cc Diesel turbo

Can someone tell confirm the CC will not work on Yaris Diesel Models?
Thanks
Kind regards

[velle]

same here, no luck. from what i ve researched you will also need to route pin cables through the wheel to the ecu

[asura6]

I successfully installed the cruise control on a 2012 french made 1.3 L 6-speed Yaris. 1NR-FE. This version of the car had a different way of removing the steering pad as it had only one hole for accessing the clips which was located around 6-o'clock. You remove the steering pad by pushing a screwdriver through the hole to disengage the bottom clip and then you can disengage the other clips by pushing the steering pad upwards just using your hands. My steering wheel had audio buttons and and call buttons. There was a vacant 4-pin connector that I simply plugged in the cruise control stalks connector into and it started working.