How to remove fog lamp covers ?

[nurburgring]

How do you guy remove the foggy covers ? Wanna open them up to let more air in.

[slvryaris]

Water may get into them and cause the bulbs to blow premature due to condensation.

[nurburgring]

Mine are just covers, I dont have fogs.

[eTiMaGo]

AFAIK they clip from the back, it'd be easier to remove the bumper to reach the clips...

[spinejaruk]

alternatively, on each side you can remove three screws and a plastic plug (where the centre screw goes in) underneath the bumper - check out the service manual fog lamps under "lighting".
Pull out and flex the plastic shielding out to one side and stick your hand in - push the clips on the fog cover outwards and push forward - it may be easier if you have a buddy to assist and jacking up the car/or put on ramps depending how fat you are....

[ROCKLAND TOYOTA]

instead of taking them out completely i thought about using the dremel to cut some slits to give it some air.....

[CKMotorsport]

How do you guy remove the foggy covers ? Wanna open them up to let more air in.

why don't u install billion air funnel and air duct instead. it's looks better.

[Astroman]

instead of taking them out completely i thought about using the dremel to cut some slits to give it some air..... That is what I'm going to do, just can't find the dremel right now..:iono:

[OxyG3nE]

iif u have the CAI it probably help to open it.. its right under where the filter goes .. was thinking about doing it too.. when its not raining..