Port&Paint Intake Manifold

[SirDigby]

hello. I have done some extensive porting on the intake manifold. I cut out the o ring valley and added JB weld as a filler in holes. I also filled o ring gap and added JB weld to the OUTSIDE where there is a sharp corner on the inside. then I went through like 100 sheets of sandpaper.




then I taped it up.

primmer
[IMG]http://www.yarisworld.com/forums/picture.php?
albumid=1179&pictureid=6104[/IMG]
then a few coats of paint, some tape, and some more paint.
then just a little clear coat...




it turned out pretty ok...