megan coilover settings - Toyota Yaris Forums

xnamerxx · 08-20-2012, 04:43 PM

With crash bolts I only got -1.5 and I needed to slot the holes to get an additional -1.5. Your neg camber can also vary depending on how much you've lowered the car as well so if Garm's lowered 3" hes going to be pretty deep into his camber curve whereas if you've only dropped an inch you won't have much camber gain. Remember suspension travels on a slight arc.

The right left readings will always be there because there is always tolerances built into everything. The .3 difference is meaningless and isn't even noticeable in most applications.

As for your rubbing you have +20 offset wheels that are 8" wide and with the relatively light spring rate in the rear with the megans and possibly a car that's been lowered to far you'll get rubbing when you hit a bump or turn hard or even have a few heavy passengers in the back.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Megan Racing header install and review with pics.	Herbicidal	Performance Modifications	6	09-03-2009 09:40 AM
Pre Hack Revival: Megan Racing Header vs Ebay Header	Sabretooth	Performance Modifications	15	08-19-2009 06:26 PM
Megan coilover fitment problem	YaYa1320	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	12	08-06-2009 09:01 PM
Megan Coilover install DIY	kapo	DIY / Maintenance / Service	5	09-24-2007 08:20 PM
Megan or Tein suspension	elmercurrie	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	43	05-31-2007 10:41 PM

08-20-2012, 04:43 PM	#19
xnamerxx 0-60 in slow Drives: light blue liftback Join Date: Aug 2009 Location: so cal Posts: 926	With crash bolts I only got -1.5 and I needed to slot the holes to get an additional -1.5. Your neg camber can also vary depending on how much you've lowered the car as well so if Garm's lowered 3" hes going to be pretty deep into his camber curve whereas if you've only dropped an inch you won't have much camber gain. Remember suspension travels on a slight arc. The right left readings will always be there because there is always tolerances built into everything. The .3 difference is meaningless and isn't even noticeable in most applications. As for your rubbing you have +20 offset wheels that are 8" wide and with the relatively light spring rate in the rear with the megans and possibly a car that's been lowered to far you'll get rubbing when you hit a bump or turn hard or even have a few heavy passengers in the back.