My 2011 Vitz - Toyota Yaris Forums

TerenceCruz · 02-11-2016, 05:09 PM

As promised ;) TRD axle back arrived and was installed yesterday!

12696021_908297325945749_1462208345_n by Tj Cruz, on Flickr

12713994_908297289279086_1244371052_n by Tj Cruz, on Flickr

Could not be ANY happier of how nice it fits under there. It has so much clearance which I needed for the cars current height. Sounds amazing too. I previously had a tanabe medalion touring axle back, but it hung so low I knew I would damage it. So I sold it before anything could happen.

12721700_908300569278758_920895044_n by Tj Cruz, on Flickr

12714344_908300582612090_1778355015_n by Tj Cruz, on Flickr

My only complaint has nothing to do with the exhaust at all, but instead it's the freakin heat shield that detached somehow (probably when I hit a fat bump) And now it makes an annoying rattling sound when it comes into contact with the piping. Anyone have any idea how that was originally attached? I tried 3M tape but it only worked for a little bit. Any help would be greatly appreciated. Thank you guys, and enjoy!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2010 Vitz RS Modellista Completed Car	Vitz Rs Modellista	Photo-Video-Media Gallery	38	11-18-2014 01:25 PM
2012 Vitz from the 2011 Tokyo Auto Salon	CTScott	Third Gen Yaris General Discussion	14	02-10-2011 09:06 AM
Is UA-NCP13 1.5L Manual Trans a Vitz RS?	WesSunday	General Yaris / Vitz Discussion	1	11-28-2010 11:47 AM
Newly refreshed 2011 Toyota Corolla	Kal-El	Off-topic / Other Cars / Everything else Discussions	23	11-27-2010 01:57 PM
A German Yaris/Vitz/Echo ;)	we-to-11	Photo-Video-Media Gallery	5	06-27-2007 09:26 PM

02-11-2016, 05:09 PM	#11
TerenceCruz Drives: 2011 Toyota Yaris Join Date: Feb 2013 Location: Cali Posts: 725	As promised ;) TRD axle back arrived and was installed yesterday! 12696021_908297325945749_1462208345_n by Tj Cruz, on Flickr 12713994_908297289279086_1244371052_n by Tj Cruz, on Flickr Could not be ANY happier of how nice it fits under there. It has so much clearance which I needed for the cars current height. Sounds amazing too. I previously had a tanabe medalion touring axle back, but it hung so low I knew I would damage it. So I sold it before anything could happen. 12721700_908300569278758_920895044_n by Tj Cruz, on Flickr 12714344_908300582612090_1778355015_n by Tj Cruz, on Flickr My only complaint has nothing to do with the exhaust at all, but instead it's the freakin heat shield that detached somehow (probably when I hit a fat bump) And now it makes an annoying rattling sound when it comes into contact with the piping. Anyone have any idea how that was originally attached? I tried 3M tape but it only worked for a little bit. Any help would be greatly appreciated. Thank you guys, and enjoy!