How do I cure a lean condition?

[Tamago]

Originally Posted by LtNoogie

Really really short. I need to jack up the car (onto stands of course), crawl underneath, and figure out the routing long before I take it to the muffler shop. There's a car stereo shop right next to them. I'm tempted to ask the installers if they'll run the cables on the side for cash.

Are the entry points on an AT the same as a MT?

yes, the same place. it should be a plate held by two bolts that the cable passes thru. my suggestion is to drill a hole in that plate, off to one side, and install a rubber grommet that you can put your wire thru.

while you're under the car, you wont' be able to see this plate without removing the exhaust heat shield. you should be able to unbolt it and slide it to the side past your exhaust and then you'll see the plate that is part of the shift cable.