Intrest in a sedan center exhaust rear section?

[malibuguy]

a tubing DIY kit would be approximately 200-300 range for aluminized steel, $75 more for 409ss.

I would sell it with hangers, but they would need to be bent and trimmed to fit. This allows for maximum flexability for the install. Ideally cut off your stock flange & reuse it. Unless i stumble upon a sutible solution for that.

Im doubtful demand would be enough to justify a full, bolt on kit that requires no work. I'll have to be moving a few kits a week to justify making the jigs for that.

I may have a chance to get the rear section started tomorrow if work is slow enough. If not, it wont be until next week as I will be out of town for the rest of the week.