RS Intake Manifold,airbox mod and 1zzfe throttle body/injectors

[Compeer]

Originally Posted by Neinris

Mine was out of a Toyota Matrix PN 22030-0D030, which I got from Ebay for $30 including shipping. I drilled out the rivets and opened up the electronics and swapped with the Yaris' and it worked without any CEL (I don't think swapping out the electronics is necessary though). I ended up putting back the stock TB though when I was hunting for a ghost fault on my Dee Dee, but ended up finding out that the ODBII reader I was using was faulty, and made me buy stuff I didn't need.

I could put it back, but I think I'll just do the throttle pedal swap instead.

Do both thats my plan, I have an is250 throttle lined up for $150 nzd and a 2zfr-fe throttle body for $128.

Originally Posted by sh0rtlife

see thats something that ive been trying to understand is "what" to pull the TB from....everyone says use the TB its a great upgrade no one bothers to mention what its from!!!!!

Short you can get them out of any toyota car with a chassis number starting with ZZE that is 2006 onwards or any ZRE starting chassis car hope that helps.

The volt Injectors I picked up



I have been busy porting and polishing the RS inlet manifold and made it an adaptor plate, now there is a nice rounded lip into the larger diameter instead of a hard edge. the inlet has had a nice internal sanding as well to remove any hard edges.




It's very soft alu and with shellac and the gasket paper facing the throttle body and the original oring this should seal perfectly.


Polished the inlet manifolds exhaust ends as they all had a lot of sharp edges inside from the casting just like the main inlet had.