RS Intake Manifold,airbox mod and 1zzfe throttle body/injectors

[Neinris]

Originally Posted by sh0rtlife

i attempted the TB board swap only to find both units used different main gears and different electric motors so much so that the "pins" off the motors wernt in the same spot.....annoyed

Which TB did you try to install? I'm not sure if the 2ZR TB would work. The one that is used was from a Toyota Matrix with 1ZZ engine, PN 22030-0D030.

[Compeer]

Originally Posted by Neinris

Which TB did you try to install? I'm not sure if the 2ZR TB would work. The one that is used was from a Toyota Matrix with 1ZZ engine, PN 22030-0D030.

I just put all the pictures up of installing the 2zr-fe throttle body, so yeah it works.

Its some of the 1az/2az that don't work, tho some of them do. It just needs to have the correct case on the back unless you get lucky and your ecu doesnt throw a fit about having a different circuit board but my car did not like the new tb until I put the 1nz-fe chip on which could just be because I have a different ecu as NZDM rather than JDM import.

[sh0rtlife]

Originally Posted by Neinris

Which TB did you try to install? I'm not sure if the 2ZR TB would work. The one that is used was from a Toyota Matrix with 1ZZ engine, PN 22030-0D030.

06 rolla S thats all im sure of....as i pulled it myself

next one i pull im drilling the rivits in the wrecker before i even leave

[Compeer]

Originally Posted by sh0rtlife

06 rolla S thats all im sure of....as i pulled it myself

next one i pull im drilling the rivits in the wrecker before i even leave

I think it needs to be genuine, if its some rando aftermarket jobby I would not even bother, its going to be different.