Making a engine wiring harness

[CTScott]

Originally Posted by maxthehax

Damn, here is the list of the connectors that I have and I need to remove pins and put new ones with new wires;

Injectors
COils
VVTI
Crank position
Cam position
Knock sensor

And those I need a new plastic connector plus the wiring;
TPS
Idle air control


If I bring all the connectors I have to my toyota dealer, do you think they have the tools to remove all the pins? They should also be able to order new pins...

Thanks!

The service techs should have the SSTs for popping the various pins. With the number you would need to pop you would probably end up with an hour or two charge.

They can order the new pins (for about $15 each), and they will each come with a piece of wire attached. You can only get the actual crimpable pins directly from the manufacturer(s) and my experience with Sumitomo is that you have to buy a minimum of 20,000 of each type of pin.