Making a engine wiring harness

[CTScott]

Originally Posted by maxthehax

Yes, that should be all.
Others gonna be AEM;
-water temp
-MAP

If I forget some I will post them later!

Thats a blast you have it all...

What about the metal pins that I need to go into the connectors?? I guess I will need special crimper.

Thanks!

Also, I have a echo, so my TB is a drive by cable. Not the electronics one

What I have are the actual OEM Yaris connectors with the OEM wires (so you would need to solder those wires to you EMS harness. The connector shells would run you about $10 each from Toyota and even they would supply the pins with a piece of wire already attached (for about $15 per pin). The reason for them being pre-crimped is that each pin type requires a completely different crimper (which are about $200 each from Sumitomo).

The TPS connector is different. The Toyota part number for the shell is: 90980-11261

The Idle Air Control connector (what you called the PWM) shell is: 90980-11145

The Crank, Cam, and OCV (VVTI) are the same for the Yaris and Echo.