Viper Alarm Install

[battleversiontc]

im actually in honolulu and install alarms on the side use to be a best buy district mobile install lead
this is for a remote start alarm

12volts yellow (25A), gray (15A) + ignition harness
h3 10pin harness red, red/white, red/black splice together
Starter black (x2)(common) + ignition harness
h3 10pin harness violet
Second Starter N/A
Ignition pink + ignition harness
h3 10 pin harness pink
Second Ignition green + ignition harness
h3 10 pin pink/white
Third Ignition N/A
Accessory white + ignition harness
h3 10 pin orange
Second Accessory N/A
Keysense yellow - ignition harness
Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.

Power Lock brown - driver kick, 20 pin plug, pin 7
Notes: Meter this wire while turning the key in the driver door key cylinder.
3 pin harness green
Power Unlock yellow to green (double pulse) - driver kick, 20 pin plug, pin 8
Notes: Meter this wire while turning the key in the driver door key cylinder.
3pin harness blue
Can also use the passenger door key cylinder unlock wire, which only requires a single pulse. It is green (-) at the fuse box, middle, 18 pin plug, pin 15.
Lock Motor white to orange 5wi driver kick, 20 pin plug, pin 10
Unlock Motor lt. blue to pink 5wi driver kick, 20 pin plug, pin 20
Parking Lights+ green + fuse box, top L, 30 pin plug, pin 29
h1 12pin white
Parking Lights- white - headlight switch
Notes: Not available on all models.
Hazards black - hazard light switch
Turn Signal(L) lt. green + fuse box, top L, 30 pin plug, pin 27
Turn Signal(R) yellow + fuse box, top L, 30 pin plug, pin 28
Reverse Light red + fuse box, top L, 30 pin plug, pin 30
Door Trigger see notes - fuse box, top left, 30 pin plug
Notes: The LF door is red in pin 21. The RF door is blue in pin 24. The LR door is green or yellow in pin 5. The RR door is blue in pin 20. The rear doors are common on some models. Use all four wires and diode isolate each.
Dome Supervision pink - fuse box, L side, 6 pin plug, pin 2
h1/8 12 pin green
Trunk/Hatch Pin lt. blue - fuse box, top L, 30 pin plug, pin 7
Hood Pin white - pin sw or theft warning ECU, pin 4
Notes: The theft warning ECU is behind the glovebox.
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock use key sense wire
Tachometer lt. green ac data link conn. under dash, pin 9
Wait to start N/A
Brake Wire green to purple + fuse box, top L, 30 pin plug, pin 12
5 pin harness brown
Parking Brake yellow - fuse box, top R, 16 pin plug, pin 2
Horn Trigger black to lt. green - fuse box, top, 36 pin plug, pin 28
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Transponder
Part #: 556UW
Alternate Part1 #: DesignTech 20402
Alternate Part2 #: DesignTech 29402
Notes: Optional on the sedans and S sedans, not standard equipment.
Smart Starter Kill Relays: Not Available

you still need to keep the h1/3 siren output wire(brown) h1/5chassis ground(black) h1/2 12v input just splice into the remote start constant wire (red) remote start input you need neutral safety (black/white) just ground it,

then thats pretty much it besides you gotta program it but where you at im free on thursday so let me know where you be or private message me a number i can help you if this all seems to be a blur