Advice on Pioneer AVH-P4000DVD instalation!!

[jdms]

hey thanks alot! For those that have Navi installed.

I'm getting my Avic d3 in this week and was looking over the installation manual and the only questions i have are:

1. What wire did you spice into for the vehicle speed sensor wire?

2. did you actually hook up the reverse wire?

3. i was reading someones install and to do the bypass (get dvds and change destination while moving) you have to ground out the e break wire. is this true.

Any help will be greatly appreciated. Someone should do a write up for DIY for navi systems

[sportin83]

Originally Posted by jdms

hey thanks alot! For those that have Navi installed.

I'm getting my Avic d3 in this week and was looking over the installation manual and the only questions i have are:

1. What wire did you spice into for the vehicle speed sensor wire?

2. did you actually hook up the reverse wire?

3. i was reading someones install and to do the bypass (get dvds and change destination while moving) you have to ground out the e break wire. is this true.

Any help will be greatly appreciated. Someone should do a write up for DIY for navi systems

you do not need the speed sense wire. the unit will do hybrid learning and will calibrate itself using the gps. the reverse wire is not needed unless you add a backup camera. and for the bypass most pioneers need software updates to override do to the built in gyro sensor. on my avic-z2 its shuts off controls at 10 or 15 mph. but all you have to do is take green wire which is ebrake wire on pioneer unit run that to a basic toggle switch and then take the other side of toggle to ground anywhere in car and then you flip switch unit thinks break is on. hope this helps