DIY - Bypassing Tire Pressure Warning System (TPWS / TPMS) - Toyota Yaris Forums

ricktoyota73 · 02-26-2009, 12:40 AM

Ok, so on a new project, I should use 130 ohm resistors, correct?
I have a bunch of 20 guage wire. Is that ok to use?
CTScott...how did you figure this shit out?
I have been working in the parts department of car dealers for the last 10 years and, from the things I've seen over the years, you never want to cut the factory wire harness. I will definitely leave enough wire where I can reconnect the SOB, but it still scares the crap out of me. It will be worth it to get rid of the cursed light, though.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Tire pressure sensors	Tink1	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	11	10-21-2008 06:53 PM
Intake Systems Decision Maker..	Blenjar	Performance Modifications	25	09-15-2007 11:07 PM
The Tire inflation debate...	Tankota	General Yaris / Vitz Discussion	20	06-01-2006 08:09 PM

02-26-2009, 12:40 AM	#10
ricktoyota73 Drives: 2014 Yaris 3-Door Join Date: Oct 2008 Location: Kalamazoo, MI Posts: 33	Ok, so on a new project, I should use 130 ohm resistors, correct? I have a bunch of 20 guage wire. Is that ok to use? CTScott...how did you figure this shit out? I have been working in the parts department of car dealers for the last 10 years and, from the things I've seen over the years, you never want to cut the factory wire harness. I will definitely leave enough wire where I can reconnect the SOB, but it still scares the crap out of me. It will be worth it to get rid of the cursed light, though.