Cheapest exhaust?

[Aothachos]

i was going to go 2.25 inch piping...is that too much?

[Tonavi]

I want a center exit but have a trailer hitch, so I'm going to do a custom dual exit setup that goes on both sides if the receiver, which is hardly visible anyway. One of my friends has a Borla muffler that is nice and loud but not ricey at all. Since there's no emissions regs should I go cat free?

[Kaotic Lazagna]

Originally Posted by Tonavi

I want a center exit but have a trailer hitch, so I'm going to do a custom dual exit setup that goes on both sides if the receiver, which is hardly visible anyway. One of my friends has a Borla muffler that is nice and loud but not ricey at all. Since there's no emissions regs should I go cat free?

Catless might make it sound ricey and obnoxiously loud.

[PETERPOOP]

Originally Posted by Kaotic Lazagna

Catless might make it sound ricey and obnoxiously loud.

If you decide to be catless and to remove your stock resonator, you can opt for hi flow cats and a 24" resonator and you should be fine. Also, the choice of muffler will also play a big role in the noise department.

If you all remember, my car was pretty loud. However, I have taken off the magnaflow muffler and put on a new one. The noise level is near the same as was my Blitz axleback. This is having no cats and a 18" resonator. I will post pics soon. Tomorrow I am having a 2.25" hi flow cat put on. This will make my setup very nice. The exhaust won't be drowning everything out, and you'll hear more of the whinnneeeee!

[Kaotic Lazagna]

Originally Posted by PETERPOOP

If you decide to be catless and to remove your stock resonator, you can opt for hi flow cats and a 24" resonator and you should be fine. Also, the choice of muffler will also play a big role in the noise department.

Borla is pretty loud, right? That was what the member is planning on getting. But yeah, 24" resonator should quiet it down. You're didn't sound ricey, but was a bit loud for me. What did you use again? That member would benefit from your specs.

*edit, either I missed the section about your specs, or you put it in after. hahahahaha.

[PETERPOOP]

Originally Posted by Aothachos

i was going to go 2.25 inch piping...is that too much?

I'd say 2" if you're not running FI. You'll lose too much torque running 2.25 being N/A.

[Kaotic Lazagna]

Originally Posted by Aothachos

i was going to go 2.25 inch piping...is that too much?

That's what I have, but in all honesty, stick to 2" unless you're planning on going force fed.