Twin turbo dual exaust yaris 1NZ-FE setup?

[ka0sx]

Originally Posted by Russelt3hPirate

seems like a hack.

make a stout mildly high compression motor (9.5:1) that makes decent power off boost then slap on a properly sized turbo 16g TD05 for example.

make about 275whp have full boost by 3500 rpm and be golden.

i said enough gases to warrant the sequential part of it. how often when in the "twisties" are you below 3k RPM?

in my old car? i never left 3rd gear, so 30% of the time, thank god for balanced runners, full torque 2400-6400 rpm.

I'm not going to argue with you as you seem to be stubborn as a mule on your opinion and apparently yours is the only one that counts. No one should ever do anything that is a viable solution everyone must conform.

[Russelt3hPirate]

Originally Posted by ka0sx

in my old car? i never left 3rd gear, so 30% of the time, thank god for balanced runners, full torque 2400-6400 rpm.

I'm not going to argue with you as you seem to be stubborn as a mule on your opinion and apparently yours is the only one that counts. No one should ever do anything that is a viable solution everyone must conform.

I'm just waiting for someone to actually come up with a viable solution that is better then the one presented above.

feel free to do so.

I'll wait here why you try and figure out how to fit two turbos in a yaris......

haha, being different simply to be different is as bad if not worse then conforming to a well thought out performance setup that will be simple to setup/maintain and will make power.

then again it is up to you, i'm merely on the other side of the internets voicing my mule of an opinion. :)