Quote:
Originally Posted by eTiMaGo
Haven't gone around to it yet, trying to get all the required tools according to the assembly manual, did you follow the instructions exactly? I don't have a vise handy, so I'm not sure how I'll be able to hammer that part out...
|
A vise isn't absolutely required. If you have a sturdy table with a hole in it, or 2 tables side by side with a small gap between them you can use that. Basically you just need a sturdy surface with a gap to allow the shifter to "hang" from the cup remover tool which is supplied with the shifter.
I hope this helps,
Kevin
TWM
12-17-2006, 01:12 PM
Similar Threads
Threaded Mode