Question regarding replacing studs...

[WeeYari]

Had to. Stock studs with a 10mm spacer only left me with approx 3 or 4 exposed threads for the wheel lugs to grip. Also explains why I responded about using an impact wrench to pull them through ;)

[DerFlosser]

Originally Posted by WeeYari

Had to. Stock studs with a 10mm spacer only left me with approx 3 or 4 exposed threads for the wheel lugs to grip. Also explains why I used an impact wrench to pull them through ;)

OK....was this on the front or rear? The reason I ask is because I am trying to find out if I am on the right track here. If it was the rear, can you install these by simply removing the drum face and hammering out the old studs while simply installing the new ones through the back of the hub face (using said washer, lugnut and impact)? I am trying to prepare myself for a simple 30 minute to 1 hour job as opposed to thinking it's super simple and spending 6 hours on it and being frustrated as all hell. Your input if greatly valued!