one down, one to go - Toyota Yaris Forums

Kaotic Lazagna · 11-16-2010, 04:20 PM

Hey Adam, is that the bolt-on projector kit? If so, I think you may have installed it incorrectly. The cut-off is going to be vertical instead of horizontal. I'm thinking this because of where the LED's for the halo is located. They should be at the bottom of the ring, but in your picture, they are facing to the left of the headlight.

?????

thebarber · 11-17-2010, 11:10 AM

Quote:

Originally Posted by Kaotic Lazagna

Hey Adam, is that the bolt-on projector kit? If so, I think you may have installed it incorrectly. The cut-off is going to be vertical instead of horizontal. I'm thinking this because of where the LED's for the halo is located. They should be at the bottom of the ring, but in your picture, they are facing to the left of the headlight.

?????

the bottom of the halo ring is pointing down

i actually installed them upside down to begin with just from taking the projector apart to look at it....

what i am doing to check the beam direction is shining an led flashlight i have thru the back of the lense....so its set up correctly, trust me.

you just have the orientation of the headlight wrong in your mind. the bottom of the headlight is the bottom left of the pic....

11-16-2010, 04:20 PM	#1
Kaotic Lazagna View User's Garage Drives: '14 GT86, '08 Vitz Join Date: Dec 2006 Location: Central Valley, CA Posts: 9,873	Hey Adam, is that the bolt-on projector kit? If so, I think you may have installed it incorrectly. The cut-off is going to be vertical instead of horizontal. I'm thinking this because of where the LED's for the halo is located. They should be at the bottom of the ring, but in your picture, they are facing to the left of the headlight. ?????