gude-head-1NZ-FE

[Parmas]

I am not into Microtech but I happen to have experienced similar engine management previousely that only is capable to activate a valve and not constantly vary angles. I am about sure to fully control the VVTi you need to change management.

In my opinion with your cam setup you will surely have nice power and torque on the upper curves ( probably above 6K depending how wild it is). But this would cost you power and torque performance at low and medium rpms. Also you should know that with these cams, there is a possiblity of a rough with rich mixture which result into an unsteady idle especially if you lock cam angle.