DIY Cruise Control on 07-08 Yaris (step by step)

[rob1005]

I just purchased the clutch switch from Toyota but it did not include any connector or wires. It just has two prongs. How would I go about attaching two wires to the prongs?

Toyota also gave me screws which are too big for the cruise stalk. Which screws do I need?

Thanks for all your help.

[CTScott]

Originally Posted by rob1005

I just purchased the clutch switch from Toyota but it did not include any connector or wires. It just has two prongs. How would I go about attaching two wires to the prongs?

Toyota also gave me screws which are too big for the cruise stalk. Which screws do I need?

Thanks for all your help.

On the clutch switched that I ship to people with 06-08's, I solder wires to the two pins and then individually heat shrink them, and then heat shrink over both as a strain relief. You could also use some very small female spade terminals, if you are not comfortable with soldering to them.

The screws are M5-.80