Toyota Yaris Forums - Ultimate Yaris Enthusiast Site
 

 


 
Go Back   Toyota Yaris Forums - Ultimate Yaris Enthusiast Site > Technical Forums > DIY / Maintenance / Service
  The Tire Rack

Reply
 
Thread Tools Display Modes
Old 04-12-2012, 10:32 AM   #1
randeez
 
Drives: 2008 3dr
Join Date: Oct 2011
Location: south florida
Posts: 67
Quote:
Originally Posted by randeez View Post
2008 polar white liftback 3dr 5sp. bought it at 30,xxx miles, up to 32,500 now
only problem so far is a little stumble i get while idling...i dont have a tach so i couldnt tell ya how many rpm it drops, but it's enough to make the car shudder for a sec or two then jumps right back up....any ideas?
5 months and 20,000 miles

just shy of 50,000 miles now, couple of syn oil changes, replacing air filter, changed plugs (no difference), still have a low idle stumble every once and a while. just rotated tires and checked brakes front/rear. finally got a ultragauge- the lack of gauges in the base model leaves mea bit worried. have it set up for instant mpg, average mpg, tach, water temp, voltage, and miles till empty- going to see if i can find oil pressure though
randeez is offline   Reply With Quote
Old 04-12-2012, 01:22 PM   #2
Kal-El
 
Kal-El's Avatar
 
Drives: 07 Yaris S Sedan 5-Speed
Join Date: Oct 2008
Location: Massachusetts
Posts: 2,179
Quote:
Originally Posted by randeez View Post
5 months and 20,000 miles
Wow, what's your commute like?
Kal-El is offline   Reply With Quote
Old 03-15-2014, 04:20 PM   #3
randeez
 
Drives: 2008 3dr
Join Date: Oct 2011
Location: south florida
Posts: 67
Quote:
Originally Posted by randeez View Post
5 months and 20,000 miles

just shy of 50,000 miles now, couple of syn oil changes, replacing air filter, changed plugs (no difference), still have a low idle stumble every once and a while. just rotated tires and checked brakes front/rear. finally got a ultragauge- the lack of gauges in the base model leaves mea bit worried. have it set up for instant mpg, average mpg, tach, water temp, voltage, and miles till empty- going to see if i can find oil pressure though
been a little while, had to jump on and order some stuff from Garm(microimage)
brakes are getting a little noisy, passenger side pad, although still having more then 50% material left, looks like it has some stress cracking and pedal feel sucks - ordered new rotors and pads, going to flush all the fluid out as well

for future use:
11/5/11 @ 32,500 (purchased shortly before)
4/12/12 @ 50,000
3/15/14 @ 123,494

Last edited by randeez; 03-15-2014 at 04:40 PM.
randeez is offline   Reply With Quote
Old 03-31-2014, 11:51 AM   #4
randeez
 
Drives: 2008 3dr
Join Date: Oct 2011
Location: south florida
Posts: 67
Quote:
Originally Posted by randeez View Post
been a little while, had to jump on and order some stuff from Garm(microimage)
brakes are getting a little noisy, passenger side pad, although still having more then 50% material left, looks like it has some stress cracking and pedal feel sucks - ordered new rotors and pads, going to flush all the fluid out as well

for future use:
11/5/11 @ 32,500 (purchased shortly before)
4/12/12 @ 50,000
3/15/14 @ 123,494
124,818 front pads/rotors and brake fluid
pads still had plenty of material, honestly think I could have gone 200k miles with oem pads- they were just breaking away from the steel backing maybe not broke in properly?
discs could have been reused/turned and reused for sure but I wasn't positive what was causing brake shake so I ordered some r1 rotors and hawk pads from micro image.

rear brakes I changed awhile ago, upon the advice of tire dick around 100k miles . I looked at them before and they didn't have much material... when he mentioned it I figured mileage had been plenty for oem to change anyway. Went ahead and ordered new ones, made the time to change em, pulled the drum off and realized they just don't have much material on them to begin with. But I had new shoes and the time to do it.
btw they quoted me almost 300bux to service rear brakes, so check em yourself they only have maybe 1/8"-3/16" of material
randeez is offline   Reply With Quote
Old 10-23-2014, 01:23 AM   #5
randeez
 
Drives: 2008 3dr
Join Date: Oct 2011
Location: south florida
Posts: 67
Quote:
Originally Posted by randeez View Post
been a little while, had to jump on and order some stuff from Garm(microimage)
brakes are getting a little noisy, passenger side pad, although still having more then 50% material left, looks like it has some stress cracking and pedal feel sucks - ordered new rotors and pads, going to flush all the fluid out as well

for future use:
11/5/11 @ 32,500 (purchased shortly before)
4/12/12 @ 50,000
3/15/14 @ 123,494
Jumped on to see if we needed to be worried bout airbag recall
I see a few more high mileage cars have come around
No issues since last check in, and I get the cup holder buzz, without the cabin filter I also get stuff down in the HVAC blower wheel too
10/23/14 @ 141,000
randeez is offline   Reply With Quote
Old 11-05-2014, 04:29 PM   #6
camoang
 
Drives: 2007 Toyota Yaris
Join Date: Sep 2014
Location: Pittsburgh, PA
Posts: 3
2007 Yaris Liftback
Blazing Blue Metallic
80,000 miles

2 new sets of tires (both Yokohama ~30,000 & ~60,000)
New brakes last summer (~60,000 miles)
Replaced driver window seal
Nothing other than routine oil changes, etc.

It has started running loud...a friend mentioned maybe the muffler might be bad. Hopefully it's nothing major.
camoang is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
excessive sulfur odor on 2007 model year Yaris tomjasz General Yaris / Vitz Discussion 121 03-13-2010 07:49 PM
TSB's WD-40 General Yaris / Vitz Discussion 27 06-06-2007 02:11 AM


All times are GMT -4. The time now is 06:02 PM.




YarisWorld
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.