 |
 |
|
|
05-27-2012, 07:35 PM
|
#6 |
 
Drives: '07 Yaris turbo, '11 Juke Join Date: Mar 2007
Location: Riverside, CA
Posts: 849
|
The big harness in front is just blue electrical tape since I couldn't find tubing that was big enough. The way it comes from the factory is just black tubing wrapped in black tape. I took the black tape off and replaced it with blue. All the other tubing and wire sleeves were bought from amazon.com and summitracing.com.
__________________
http://www.cardomain.com/ride/3875996 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: 10 minute engine bay detail | Razr | DIY / Maintenance / Service | 61 | 07-28-2020 03:33 PM |
| DIY: LED side mirror installation | eTiMaGo | DIY / Maintenance / Service | 85 | 06-24-2011 12:48 PM |
| Engine bay prettification project | eTiMaGo | Cosmetic Modifications (Exterior/Interior) | 14 | 04-23-2007 05:22 PM |
| swap for 2zz-ge???? | yarisTOONR82 | Performance Modifications | 12 | 03-23-2007 08:15 PM |
| Q about Routing wires to the engine compartment | W.A.S.P | In Car Entertainment + Electronics (audio / video / alarm) | 10 | 11-01-2006 08:36 PM |
Threaded Mode