 |
 |
|
|
06-03-2012, 08:44 PM
|
#8 |
|
Takes corners too fast!
Drives: Absolute Red 2009 Yaris HB Join Date: Apr 2012
Location: Columbia, SC
Posts: 830
|
yea sounds like it, lucky it is still under warranty so you shouldn't have any problems after that unless you get a double lemon part.
__________________
mods:15''Drag DR21 w/Nitto NeoGen 205/50R15, Tanabe DF210 lowering springs 1.6/1.8, TRD Rear Sway Bar, Tanabe Front Sway Bar, Micro Image Short Throw Shift Kit (both in and under), 8.64lbs flywheel, F1 Stage 4 Clutch, AEM Cold Air Intake (Red), Megan Racing Header, DC Sports Axle Back Exhaust, Micro Image Crank Pulley, NST lite Alternator Pulley, ARP Manifold Stud Kit,Tanabe Front Strut Tower Brace, ScanGuage II, Micro Image Silicone Radiator Hose Kit (Red), NRG Carbon Fiber Shift Knob (round), 2009-2011 Toyota Yaris Liftback Foglight kit, NRG Grounding Kit (Red), Hella Horns(Red),CF Hood |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Alternator Bearing | barryware | DIY / Maintenance / Service | 7 | 11-23-2013 06:33 PM |
| Bad trans bearing | Topaz540i | DIY / Maintenance / Service | 9 | 04-15-2013 02:51 PM |
| Rod knock or Main bearing knock? | jabranko | General Yaris / Vitz Discussion | 27 | 08-05-2011 11:14 AM |
| Urgent advise Needed MT Clutch & Bearing Spec. | victorddr | DIY / Maintenance / Service | 4 | 04-23-2011 10:27 AM |
| Front Wheel Bearing Failure | craigq | DIY / Maintenance / Service | 4 | 08-17-2007 07:26 AM |
Threaded Mode