Quote:
Originally Posted by caineroad
According to the manual i received,
ON wire - connect to ignition, 12V - 5amp circuit
red wire - connect to accessory, 12V - 20amp circuit
The way I connect the red wire to the spade terminal in the DIY, is it going to be ok?
|
OK - The big question is just how much current the ON wire is drawing. Apparently it is more than just the switching current of a relay coil.
You could connect the ON wire to the high current spade (along with the other red), but you would lose ignition switching for the seat heaters. You could add another relay, per my DIY, and do the ignition switching that way.
10-29-2012, 07:54 AM
Threaded Mode