Prius Pistons

[tooter]

Originally Posted by JustDidIt

If if you weren't the original.. "Imitation Is The Best Form Of Flattery"... Your idea to hack up a manifold and try something new got me thinking. The way my MG1/MG2 sits, I could never use the 1NZ-FE intake or even your 'Tooter manifold' - the throttle body would conflict with my inverter. But I was thinking of doing something with the 2AZFE intake manifold because the throttle body would come out the passenger side...problem is - the manifold is plastic.

Is this the layout of your engine? And if it is, is your intake at the front of the engine or behind it?

Not sure how I could 'weld' the 1NZ flange onto the 2AZFE plastic tubing :(

I'm not sure, but I think that the plastic might have been ultrasonically welded. And that "snail" style manifold might still have clearance issues, but that could be easily determined simply by taking some measurements.

I may just have to make/design my own. Luckily you already have the flange I need to weld onto!

No rpoblem.
I'll always be stocking them. Since the design is finalized they can be manufactured as needed.