 |
 |
|
|
07-18-2013, 11:33 PM
|
#7 |
 Drives: Sedan 07 Join Date: Oct 2012
Location: Asia
Posts: 478
|
curious question CTScott, is it good for a manual tranny? I drive normally, but because of inconsistent fuel economy figures sometimes on a drive it like a stole it manner (some nights/highway).
I still can't figure out the best shifting points that will keep fuel economy figures high. the manual states the best shift points but they're usually on 3k rpm point. are those accurate? or should i unplug the negative terminal then drive normal 100% (or for most of the time)? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY - How to remove or insert a pin on the ECM Connector A21 | CTScott | DIY / Maintenance / Service | 6 | 05-21-2024 12:29 PM |
| WTB: ECM connectors(car side) + ECM male connector(ECM side) | mazilla | Willing to Buy by private party | 5 | 10-03-2011 09:25 PM |
| The "let's brainstorm how to make a piggyback work" thread | eTiMaGo | Forced Induction Forum | 83 | 08-17-2011 03:54 PM |
| ecm controller | yaris9876 | DIY / Maintenance / Service | 0 | 05-26-2010 08:06 PM |
| Yaris has a learning ecu? | YogiYaris | Performance Modifications | 9 | 05-30-2007 07:03 PM |
Threaded Mode